I happened to find there is no word about Samxon GC on Man Yues website.
Is that just some error or they just ended it without saying anything?
Is that just some error or they just ended it without saying anything?
-
Less jewellery, more gold into electrotech industry!
Half of the computer problems is caused by bad contacts 
Exclusive caps, meters and more!Hardware Insights - power supply reviews and more!
-
Hello.
I have 29inch LG CRT TV,And Yesterday,Whenever I connect AC power cord to power outlet without switch on, I heard a sound like white noise, And When I switched on this CRT TV, It sometime displayed correctly But usually It won't last more than 20 minute and The screen begin to dark and It finally did not display at all for hours..
Today,I dismantled its plastic case and discharged the biggest capacitor(400wv 470uf) which still holds 250 voltage,and I finally detached PCB from cathode-ray tube.
I measured ESR value of most of caps in PCB with MESR-100 and I found that KME(25v... -
Hi all,
I need your advice.
-SAMXON 2200uf 50V tested 0.00 esr on Dick Smith Blue Esr meter and 2027 ohm on FLUKE 179 multimeter.
-Is this esr reading realistic?
Thank you -
Hi,
I have HP 400 G6 DM which is not booting - it will spin up for like 30 seconds, then turn off for a few, boot again... and it goes on forever.
Can anyone check this dump and maybe attempt to repair it?
SN is 8CC1340PC8. Board is "Missandei-AUD Rev B Model F91" DAF91MB16B0... -
Found monitor on my way home sitting on the pavement.
This monitor stopped working due to Samxon GF failing.
One of the caps even changed color to black from overheating. Notice that even the rubber bangs deformed from venting/overheating
It is just stupid to put caps right above secondary rectifiers and heatsink that get very hot during monitor operation.
Those 17" monitors can be found in working condition for less than 10 euros or even for free!
So, I recapped it using terrible caps and tried to install extra... -
I pull a buch of (Teapo, Samxon, Ltec, Taicon, etc.) caps from older power supplies and they always check out very low ESR and capacitance in spec. Are chinese caps much better than they used to be?