Sharp Lc-42SB55E problem

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • domix
    Senior Member
    • Jan 2014
    • 166
    • Slovenia

    #1

    Sharp Lc-42SB55E problem

    Hello,

    I have this tv. One day i turn it on it was like all buttona all presed, tv just jumps thru menu, volume is going down automaticly.

    I open it and disconnect side buttons. Then i turn tv on and it was normal, but o dont have commens on tv. If i press button on remote, light on tv for remote blink but nothing happends. If i connect side buttons back, volume goimg sown again and inpust source changed automaticy.

    I chec the mein board and buy used one from ebay. The boards have boats the same number 715T3251-3 (WK:827). But this whis i bougt was from 26” inch tv with the same numbers on it.

    I replaced the board and turn tv on. Side button an IR remote dont work. Input is on HDMI 2, whic i need because i have conneted only on hdmi, tv is in living room and reciever box is connected with hdmi.

    Problem is when image shows. The image is like pattern, i have two image on screen (image and half) one at top and half one at bottom. How can i resite image to fit screen.

    Thanks
  • Andrew F. Ali
    Badcaps Legend
    • Jan 2014
    • 2450
    • Trinidad & Tobago

    #2
    Re: Sharp Lc-42SB55E problem

    There would be other numbers that should be matched but most likely different from your original board. You have the wrong Main Bd and so the software would be different for a 26inch TV.

    Comment

    • budm
      Badcaps Legend
      • Feb 2010
      • 40746
      • USA

      #3
      Re: Sharp Lc-42SB55E problem

      715T3251-3 is the blank circuit board P/N not the stuffed circuit board assembly P/N.
      Blank board can be stuffed to make many bard assemblies for many model of TV's.
      You need to match the barcode numbers.
      Never stop learning
      Basic LCD TV and Monitor troubleshooting guides.
      http://www.badcaps.net/forum/showthr...956#post305956

      Voltage Regulator (LDO) testing:
      http://www.badcaps.net/forum/showthr...999#post300999

      Inverter testing using old CFL:
      http://www.badcaps.net/forum/showthr...er+testing+cfl

      Tear down pictures : Hit the ">" Show Albums and stories" on the left side
      http://s807.photobucket.com/user/budm/library/

      TV Factory reset codes listing:
      http://www.badcaps.net/forum/showthread.php?t=24809

      Comment

      • nomoresonys
        Badcaps Legend
        • Jan 2013
        • 12206
        • U.S.

        #4
        Re: Sharp Lc-42SB55E problem

        https://www.ebay.co.uk/itm/715T2950-...xcTK:rk:1:pf:0
        Quit because THIS SITE LETS A ROGUE MEMBER TYPE ANY GARBAGE HE PLEASES AND THE POWERS THAT BE NEVER DO ANYTHING ABOUT IT SO HE NEVER QUITS. THEN YOU GET A PENALTY FOR RESPONDING TO HIS ATTACKS. BEEN GOING ON FOR WAY TOO LONG. DONE SUPPORTING A SITE THAT ALLOWS THIS BS.

        Comment

        Related Topics

        Collapse

        • Rozp
          70LE660U dark cloud or black screen with sound.
          by Rozp
          Hello Everyone,

          This is my first post so I will try to be as precise as possible without making this post too long winded. Unfortunately I don't have pictures of the original problem but I included images of the TV internals.

          I have a Sharp 70LE660U. The problem started a few months ago with the bottom row looking out of sync and was dark on the left side and then fading to transparent on the right side. Shortly after, a dark cloud appeared in the center of the screen. The dark cloud started small and shaded but the image was visible. It also affected the menu area....
          08-29-2023, 05:25 PM
        • shlomim412
          samsung ua55es6800 - no image
          by shlomim412
          hi
          having problem with samsung ua55es6800

          tv had backlight on, sound working - responds to the remote control but no image.

          check tcon board - had 12v in but no other voltages present.
          when disconnected left ribbon cable - got back voltages and half image with lines and distorsion

          when leaving only left side connected - again no voltages and no image.

          put a tape on all (cd?! lines) on the left ribbon cable and got complete but distorted image (horizontal lines).

          kept trying to block less pins on the left ribbon cable...
          05-15-2024, 05:00 AM
        • jeangonbay
          Display problem on Kryster KLED403DC TV
          by jeangonbay
          Hello, I will explain all the steps I took:

          TV model: KRYSTER KLED403DC
          Mainboard: TP.SIS231.P83
          Panel info: TY390LK02-ACW1 / V390HJ1-XC01 / V390HJ1-P02 REV C1

          So, at first the TV stuckl on the KRYSTER logo, a brand which seems to be sold, apparently only on Reunion Island, the place where I am located.

          So I looked for dumps compatible with the motherboard, which I could inject via USB key, with the file name SISEU23X8M.bin.

          Several worked, but the display was inverted, so head down, and I did not have a remote control available at...
          08-22-2024, 02:30 PM
        • Document Archive
          HP Elite Slice G2 + Image Load & Asset Tag Elite Slice i5-7500T Specification for Upgrade or Repair
          by Document Archive
          This specification for the HP Elite Slice G2 + Image Load & Asset Tag can be useful for upgrading or repairing a desktop PC that is not working. As a community we are working through our specifications to add valuable data like the Elite Slice G2 + Image Load & Asset Tag boardview and Elite Slice G2 + Image Load & Asset Tag schematic. Our users have donated over 1 million documents which are being added to the site. This page will be updated soon with additional information. Alternatively you can request additional help from our users directly on the relevant badcaps forum. Please...
          09-12-2024, 02:20 PM
        • vabea
          Asus X550LD Image problem
          by vabea
          Hello i have this notebook Asus X550ld they work normal but the image appears with interference (like video attach) i have try, New lcd and a new cable, but unsuccessful if i connect to a external monitor the imagem in the external monitor is normal without interference, any help?
          Thanks...
          04-07-2025, 08:33 AM
        • Loading...
        • No more items.
        Working...