LG 50PG60 Main Board

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • mmartell
    Badcaps Legend
    • Oct 2013
    • 3189
    • Canada
    #1

    LG 50PG60 Main Board

    Set was priming when plugged but no pic and non responsive to remote. Jumper on Logic board comfirmed good test patterns.

    Main board is part number EBT51299502 which is rather expensive. Does anyone have any knowledge of failure modes for this board or have knowledge of a reasonably priced substitute ?
    Attached Files
    Tags: None
    • ReeceyBurger123
      Never Give Up !
      • May 2014
      • 7325
      • Britain
      #2
      Re: LG 50PG60 Main Board

      Bga solder failure on main processor I had this on them boards.
      Please Do Not PM My Page Asking For Help Badcaps Is The Place For Advise, Page Linked For Business Reasons Only. Anyone Doing So Will Be Banned Instantly !

      https://www.facebook.com/Telford-Tel...7894576335359/

        Comment

        • mmartell
          Badcaps Legend
          • Oct 2013
          • 3189
          • Canada
          #3
          Re: LG 50PG60 Main Board

          You are correct Reecey! Some time later after I posted I tried again with a copious amount of hair dryer heat (I had tried when I first cracked the back off) and she fired up and works as normal.

          Now what ? Can't say I've done a successful reflow - a little gunshy from when my first attempt at reflow caused a solder ball to come rolling out from under the chip lol. Any suggestions ?

            Comment

            Previous template Next

            Related Topics

            Collapse
            • ygorsan
              LG 55NANO77SRA TV ā€“ Menu scrolling by itself even after removing button board (Main Board EBU66792103)
              by ygorsan
              Hi everyone,




              Iā€™m looking for help with a persistent issue on an LG TV model 55NANO77SRA, which uses the main board EBU66792103 (also used in LG UQ80 and NANO75/NANO80 series).







              šŸ§© Problem Summary:
              • The TV keeps scrolling through the menu or selecting items by itself.
              • I removed the physical button board (the entire panel with power and volume buttons) and also disconnected the flat cable (CN202) from the main board.
              • The remote control is not in use (batteries removed), and the TV still shows the same behavior.
              • I
              ...
              07-28-2025, 08:34 AM
            • jb_Bak
              Sony xbr-65x900c main board issues?
              by jb_Bak
              Hey guys great forum glad to have found it. I bought a Sony XBR 65X900C cheaply because it didn't work. No signs of life at all not even a light/led. All I hear is a brief high voltage sound when I throw the power to it.

              Didn't see any obvious signs of damage so right away started checking voltages. This is what I see:
              Power Board Connector that goes to Main board
              CN6401
              Pin 01 NC
              Pin 02 NC
              Pin 03 "BL_ON": 0V
              Pin 04 "N/C"
              Pin 05 "STBY 3.3V": 3.5V
              Pin 06 "GND": N/C
              Pin 07 "AC_OFF"...
              09-27-2021, 04:52 PM
            • JDC
              (SOLVED) - ONN 100012588 No Power, Then Rebooting After Main Board Change
              by JDC
              ONN 100012588
              Issue: No Power, Then Rebooting After Main Board Change

              Short answer: replace main board and power board
              Technical answer: replace main board and Q306 & Q307 on power board.

              Long answer:

              TV wouldn't turn on. Power switch was fine which means the main board isn't processing the power on signal. Replaced main board. TV turns on now but randomly reboots. Bad main board? EEPROM? Tried to pull main board and got a shock touching the corner of the board. That's weird. C334 (450V 10uf) capacitor is still holding a high charge....
              07-15-2022, 07:39 AM
            • m1ch43lzm
              HP Pavilion 15-eh Board DAG7HAMB8F0 - CPU throttling to 0.4GHz (PROCHOT_EXT) and black screen
              by m1ch43lzm
              Hi, this is my personal laptop, which the original board (lets call it Board A) blew up PU8700 (TPS51486), making a hole on the board, i had left the laptop at my desk one day with the battery fully charged and didn't touch it for a week, but when i tried to turn it on it didn't
              Thought the battery was dead, so i plugged in the charger then tried to power on, the power LED blinked once, charged LED still orange, unplugged the charger, plugged in again and I noticed the "magic smoke" smell, so i unplugged the charger, removed the back cover and saw the blown IC (the "magic...
              05-12-2025, 08:37 PM
            • cheeky2
              Is it possible to upgrade from a Vestel 17MB97 main board to a 17MB110 Main board?
              by cheeky2
              I suppose the real question is whether the existing pinouts from ether a 17IPS71 psu are cross compatible with a 17IPS12 psu? If they are then the exchange of the main boards should have no issues providing the screen is compatible with both main boards. Obviously you can change the screen configurations easily enough (providing you have the correct files) for the main board. Why may you ask would I do this? Well a lot of the smart features are no longer working on a Hitachi 48HBT62U main board I wish to give it a new lease of life!
              Obviously the same LVDS connector for the screen connection...
              05-25-2024, 03:27 AM
            • Loading...
            • No more items.
            Working...