Re: Pioneer lx6090 2 x flashing red light at start up
Did some investigation and checked the IC's from the new board. Almost all of them are shorted (the ones that are fitted against the aluminium cooling blocks), only 2 not so probably the other ydrive is a faulty one. Are the IC parallel on each, so if one is shorted the other measure also faulty, do you need to desolder these to check or can i figure out witch is faulty or could these all faulty as well ?
Did some investigation and checked the IC's from the new board. Almost all of them are shorted (the ones that are fitted against the aluminium cooling blocks), only 2 not so probably the other ydrive is a faulty one. Are the IC parallel on each, so if one is shorted the other measure also faulty, do you need to desolder these to check or can i figure out witch is faulty or could these all faulty as well ?
Comment