Hey guys, i have this panasonic plasma here and it had the typical problem with the ss having a bad ground because of the screws they used.
I bought the repair kit from shop jimmy to repair the board myself.
I completed the repair and noticed a couple of traces were damaged around the 8 pin IC. i repaired them and checked them with a multimeter.
I plugged the TV in and it took about 3 seconds then i heard a relay switch on and it tripped the 15A breaker in my house.
Is there any way to troubleshoot this SS board?
If i unplug the SS board it does the 8 blink symptom of a bad ss board.
Any help would be appreciated.
P.S. I repair circuit boards all the time, even on galaxy tabs(haha). I dont believe the problem to be a bad repair job, but am willing to test for it if i had more insight.
Thanks
I bought the repair kit from shop jimmy to repair the board myself.
I completed the repair and noticed a couple of traces were damaged around the 8 pin IC. i repaired them and checked them with a multimeter.
I plugged the TV in and it took about 3 seconds then i heard a relay switch on and it tripped the 15A breaker in my house.
Is there any way to troubleshoot this SS board?
If i unplug the SS board it does the 8 blink symptom of a bad ss board.
Any help would be appreciated.
P.S. I repair circuit boards all the time, even on galaxy tabs(haha). I dont believe the problem to be a bad repair job, but am willing to test for it if i had more insight.
Thanks
Comment