If anyone happens to find themselves working on this TV's psu (WYL MP0832...also goes by SABA MP0836)...this TV can take a Megmeet MP116A psu. You're going to have to make it "fit", as the latter is smaller, but it will power the set properly.
-
hello
I am looking for two ics on this mb:
1st marked 947 and secound sot23-5 marked 5af8b
thanks and regards... -
Any one with a working bios bin file for HP ENVY x360 - 15-dr1017tx (15.6 SABA MB WHL_4 VRAM 18748-1) Product number 8QW26PA. Powers on but no display. Tried to clean me region but not sure if i did it right. Many thanks in advance.... -
VisionQuest 24" monitor
Product name: VQL-24WD
Model: 1,050
Manufactured: July 2009
Problem: Works sometimes. When on, stays on until screen or laptop are turned off. Restarting can take weeks.
Background: Bought new around 2010. Used for 2-3 years, then had problems, stopped using. Sat around until a few months ago. Plugged it in to laptop and it worked! Used it for around a month at a time, a couple of times. However, when screen or laptop went to sleep or laptop turned off, then turned on again, monitor was dead. (I kept laptop on and... -
Hi All,
I have an old 2006 ish TV that after the last storm we had would fail to come out of standby. We had a few outages on off on off etc
I am only repairing this as a challenge and to improve my skills.
Firstly I would like to mention I am no stranger to working with high voltages and understand the dangers of the high voltages present in SMPS, I have repaired a few before but this one is a little more challenging.
The board is a Megmeet MLT666T REV: 1.2a
The symptoms. TV has standby power, when turned on the power led will... -
In the process of replacing the combine, I accidentally shifted the resistors near it, after installation I put everything back in place, but now I am tormented by doubts whether I put them correctly. There is no documentation for this platform, who can help with the resistor values?
Interested in R301, R708, R702, R707 and the one below R702....