Philips 65OLED818/12 FZ1

[nlc2000]

Hello,

I recently installed a new SSB board (model from ASWO) in my Philips 65OLED818/12 FZ1 television after the original board failed due to a lightning strike. The TV now powers on and the Ambilight works, but there is no picture displayed.

I believe the panel ID is TPM23.1E, but I can provide the exact panel code if needed.

Could you provide the correct NVM.bin file for this model and panel? If there is another solution—such as firmware or service mode initialization—I would greatly appreciate your guidance.

Thank you in advance for your help.

[Diah]

if yours panel TPM22, follow this instruction to turn it on the screen and change the OLED at Factory mode
This attachment will be delete in 24 hours

[nlc2000]

Thank you so much for this, i will try, but i'm sure that my panel is TPM23.1E. Do you have any solution for this model?

[Diah]

first step to inter Factory Mode are belong to the MB. so try that first

use this method OLED8x8

[William1967]

Thank you so much for this, i will try, but i'm sure that my panel is TPM23.1E. Do you have any solution for this model?

That's a chassis code and has nothing to do with a panel. If you search for TPM23.1E you will find the service manual.

Programming the panel code and option numbers at the same time is done with the setoption number that you can find on the rear cover. It's a 3 digit number, to program the code press 062598 home xxx where xxx is the 3 digit code.

[Diah]

That's a chassis code and has nothing to do with a panel. If you search for TPM23.1E you will find the service manual.

Programming the panel code and option numbers at the same time is done with the setoption number that you can find on the rear cover. It's a 3 digit number, to program the code press 062598 home xxx where xxx is the 3 digit code.

F ( Factory mode) will switch any panel ON., the file NVM.EED are include above to switch panel on

[nlc2000]

Thank you! I will try!

[William1967]

F ( Factory mode) will switch any panel ON., the file NVM.EED are include above to switch panel on

You don't need a visible image to enter the set option code, as this also sets the options for the motherboard in question.

[nomoresonys]

You don't need a visible image to enter the set option code, as this also sets the options for the motherboard in question.

Is that the whole procedure if no display, 062598-home-the 3 digit code, then just turn tv off?

[William1967]

For devices manufactured before 2016, only the panel ID is changed, and the device automatically goes into standby mode when the code is accepted.
For devices manufactured from 2016 and up, not only the panel ID is changed, but all options are also configured. After entering the code, you must restart the TV manually. The set option code can also be entered using an NVM.eed file.
The procedure is the same for both types.

[nomoresonys]

Thank you William1967.