jvc lt49c862 firmware needed (I think)

[Chrissygizmo]

Hi all, ive been asked to repair a jvc lt49c862 , basically when I switch it on it lights up (blueish so it needs backlights replacing) the jvc logo appears then it goes off again but all the while the standby light continues to flash constantly, i tried changing the main board to one from the same model tv but it didn't work at all so I'm guessing that board is broken, I would be grateful if anyone could point me in the right direction...

Thank you in advance

[Bholu]

I think hear u will find the firmware for free.(https://receiverpro.net/jvc-led-tv-s...-download/)may be it will help u.but I think u have faulty panel scaler pcb check may be there any short circuit or broken part.

[Chrissygizmo]

I've just checked that link you sent but it comes up as 404 PAGE NOT FOUND

[vinceroger69]

seems like a common issue JVC LT-49C862 Smart TV won't load | Tech Support Forum

[Diah]

first be sure the leds BL are fine.... seconds write the mainboards label 17MB ????

[vinceroger69]

first be sure the leds BL are fine.... seconds write the mainboards label 17MB ????

Looking at picture 6 i think its a 17mb120