Samsung LN40C500F3FXZA Power on issue

Collapse
X
Collapse
 
  • Page of 2
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
  • whatusername
    Badcaps Veteran
    • Dec 2013
    • 456
    • United States
    #21
    Re: Samsung LN40C500F3FXZA Power on issue

    Update: Replaced main board and the tv turned on no problem... On the side note Tom i looked at vt803 with a magnifying glass on the new board and it definitely is blown on my old board but there is no number on it its just a little black thing between the 2 sides. almost like it would b some kind of fuse

      Comment

      • tom66
        EVs Rule
        • Apr 2011
        • 32560
        • UK
        #22
        Re: Samsung LN40C500F3FXZA Power on issue

        Glad to hear, wouldn't expect that to have any markings, it might be a ferrite bead which isn't the same as a fuse but when overloaded can fail in much the same way.
        Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
        For service manual, schematic, boardview (board view), datasheet, cad - use our search.

          Comment

          Previous 1 2 template Next

          Related Topics

          Collapse
          • GLISIT
            Asus Probook P5440UF-XB74 power issue
            by GLISIT
            Hi all,

            TL;DR - this laptop is driving me nuts with the oddball power-related behaviors. Appreciate any insight you can provide!


            I'm experiencing a power issue on an Asus Probook P5440UF-XB74. Although I've worked with electronics and computers for decades, this is my first attempt at getting into motherboard-level component troubleshooting. Any help the community can provide is greatly appreciated!

            A few weeks ago I was using the laptop (on battery power) for a Zoom meeting. The battery was running very low (long meeting) but I wasn't worried about...
            01-16-2025, 02:29 PM
          • Asraf Atb
            Help Needed: Samsung UE55MU8000 Dead - Possible Main Board Issue
            by Asraf Atb
            Hi everyone,

            Im looking for some advice regarding my Samsung UE55MU8000 TV with main board model BN94-11606C. The TV suddenly stopped turning on and now shows no signs of life at all not even the standby light at the bottom.

            Initially, I suspected an issue with the PSU, so I took it to a repair center. They tested it and confirmed that the PSU works perfectly, even on other TVs. Based on that, I started investigating the main board.

            I disconnected the main board from the PSU, and the backlight turned on, which seems to confirm the main board is the issue....
            1 Photo
            01-27-2025, 05:02 PM
          • Cooperr
            Samsung 59" plasma PN59D550C1F seeking advice on mystery power board issue
            by Cooperr
            I picked up this TV from Facebook Marketplace, original owner described it as "screen went black after a pop" and I hoped to see an obvious fuse or cap to replace. Doesn't seem to be the case, but my experience and electrical knowledge are kind of limited for this.

            The power board (BN44-00445A, see attached) turns on and Vs and Va seem to momentarily have power, then they steadily drain to zero over a minute or two as if they're only getting power from capacitors. I've been measuring Vs and Va from the test pads, with and without the other boards connected to the power board...
            10-21-2025, 01:11 PM
          • Dani_2024
            Sceptre U550CV-UMR 4K LED, Bad Caps on Main Power Board?
            by Dani_2024
            Hi and thanks in advance for any input you might provide!
            I have a Sceptre U550CV-UMRD8POTV83BB 4K LED (this is a dumb tv) that I bought new in August 2021, so It's just completed 3 years.
            Main power board model: TP.MS3683.PC821 T-Con board: N4TP546UHDPU2L_BO

            Last Sunday I was watching a dvd and fell asleep for about half hour, when I awoke the tv screen was black and couldn't get the dvd menu to show, so I changed the input to antenna and had sound but no picture, turned it off. I then got online and found this great site! ....read many troubleshooting tips and this...
            5 Photos
            10-28-2024, 05:06 PM
          • Tynan Dill
            Vizio e601i-A3 - Has Sound and Display, But No Backlight - Bad Power Supply Board or Bad LED Bulbs ?
            by Tynan Dill
            I was given this TV from my great uncle. He said it just wouldn't turn on one day out of nowhere, replaced the TV, and gave it to me to possibly fix and use for myself.

            Upon bringing it home and plugging it up, it showed a standby light.

            I powered it on and without a flashlight, the display showed the "V" but the lighting is very dim, but visible.

            The screen seems to blackout and stay black, but with a flashlight I can see the display.

            With my Playstation 4 connected via HDMI, and running a game I can hear sound.

            Assuming...
            ORIGINAL POWER SUPPLY BOARD
            7 Photos
            11-22-2024, 01:46 PM
          • Loading...
          • No more items.
          Working...