Re: sanyo
sorry budm, I try until my eyes hurt. the only thing I see is either a m or n a5 and 1. the rest is unreadable.
sorry budm, I try until my eyes hurt. the only thing I see is either a m or n a5 and 1. the rest is unreadable.
-
-
Re: sanyo
Budm, this is what I found out of u1504 5 4
6 3
7 2
8 1
on pin 2 show .29v on pin 6 show 11.v The rest of pin have no volts.Comment
-
Re: sanyo
I do not know if it is Dual MOSFET or what, it will hard to figure out the circuit without knowing what that part is.Never stop learning
Basic LCD TV and Monitor troubleshooting guides.
http://www.badcaps.net/forum/showthr...956#post305956
Voltage Regulator (LDO) testing:
http://www.badcaps.net/forum/showthr...999#post300999
Inverter testing using old CFL:
http://www.badcaps.net/forum/showthr...er+testing+cfl
Tear down pictures : Hit the ">" Show Albums and stories" on the left side
http://s807.photobucket.com/user/budm/library/
TV Factory reset codes listing:
http://www.badcaps.net/forum/showthread.php?t=24809Comment
-
Re: sanyo
Sorry, I was out of tow. I has try to see if I can get any type of number but is impossible do to the condition of the chip. should I try something else or should I get a board thru ebay? Do you think the main board has anything to do with the problem? If there a possibility that both board are bad? It can become quite expensive if I has to replace both.Comment
-
Re: sanyo
Let me know what do you think. Will way for your answer before make a decision.Comment
Comment