Sony Bravia 40" LCD TV KLV-40S400A - Works fine at first then lines after warm up

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • funtastic
    Senior Member
    • Nov 2012
    • 63
    • New Zealand
    #1

    Sony Bravia 40" LCD TV KLV-40S400A - Works fine at first then lines after warm up

    Hi all,

    I'm looking at buying the above lcd tv from an auction site and it states that after it warms up it has intermittent lines down part of the screen and just wondering if it's worth buying for 50 NZD.

    Would it be the t-con, panel or something else? I won't bother if it's a bad panel.
    Tags: None
    • tom66
      EVs Rule
      • Apr 2011
      • 32560
      • UK
      #2
      Re: Sony Bravia 40" LCD TV KLV-40S400A - Works fine at first then lines after warm up

      It's probably a LCD tab bond issue.
      Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
      For service manual, schematic, boardview (board view), datasheet, cad - use our search.

        Comment

        Previous template Next

        Related Topics

        Collapse
        • thstuff
          SONY BRAVIA XBR-55A8H - White horizontal lines / red LED flashes four times
          by thstuff
          This "free from a friend who was going to recycle it" SONY BRAVIA XBR-55A8H arrived with the bottom center RED LED repeating a four flash pattern. It was treated with kid gloves and was reported to have "just gone dead" and the OLED panel has no dents in the metal frame or cracks.

          Thread https://www.badcaps.net/forum/showthread.php?p=1091829 helped in proceeding as follows:
          1) Unplugged, then plugged set in while holding the remote VOL- and Power to factory reset.

          2) Waited 30 seconds, then pressed remote Power button and "Select language"...
          01-30-2023, 05:01 PM
        • visionbluedemon
          Help. Sony kd-65x85dj vertical lines
          by visionbluedemon
          First. it has no picture at all. i solved it by covering the ckv lines using tape to to block the connections

          Second. now has picture but with vertical lines that follow the image. tcon board ic overheating

          tried blocking LC lines too, but same results



          is it lcd panel issue or tcon board issue?...
          07-25-2025, 04:56 AM
        • ggil44
          Sony XBR-65X750D Horizontal lines bottom of screen
          by ggil44
          Hi, I have a Sony XBR-65X750D that has horizontal lines at the bottom 6 inches of the screen. These lines appear to be every other line because the picture is still quite visible behind those lines. The lines appear all the time with a few other lines above and below the 6 inch level blinking on and off at about 2 second intervals. I'm not sure if this is a panel issue or power supply/main board problem. I did replace the T-Con board without any change in the problem. Any suggestions you might have would be greatly appreciated. Thanks,
          05-30-2023, 07:51 PM
        • PopsCaps
          Sony Bravia KDL-40V2500 that will not power on
          by PopsCaps
          I have a Sony Bravia KDL-40V2500 that will not power on. The indicator flashes red 3 times.
          I do not hear any sound and I cannot see any backlight.
          I have tried disconnecting every cable on each board one at a time to see if anything changes.
          The only change is when I disconnect AC-DET cable on the Power Supply board or on the other end if I unplug the CN7009 connection on the B-Board and try to power on the TV the indicator will stay on solid green until I power off.
          My friend ordered another used power supply board but it is also doing the red indicator flash 3 times...
          03-25-2025, 11:23 AM
        • Chrissygizmo
          Sony KD-55XG9505 lines on screen problem
          by Chrissygizmo
          Hello again everyone,

          This is my latest mission, to try getting this Sony tv back to normal working order…

          I've only just got it today, when you power it up everything is as should be, in fact it works perfectly for a few minutes then the screen starts getting horizontal lines on & eventually the full screen goes back, I will upload photos of the problem & also some photos of the board etc. You might notice that I'm busy trying the tape method, I'm not sure exactly where the clock lines are so I'm just guessing & hoping for the best lol . I've already tried...
          02-19-2025, 11:31 AM
        • Loading...
        • No more items.
        Working...