I just picked up a 65" Mitsubishi LDT651L LCD Monitor. It's a monster!
It powers up, and seems to respond to commands. the problem is the on-screen image is pretty scrambled. when I power up with no input, I see boxes where the menus should be, but they are crazy looking. ( see attachment, for what would be the "no video input" message.)
Feeding an input gives me a full screen of out-of-sync looking madness.
pressing the menu button in this case changes the whole screen to blue-ish out of sync looking stuff- exiting the menu, goes back to the other state. It seems to obey the remote and act normally otherwise..
Could this be a t-con, main board or power supply cap problem?
I've ruled out the display itself as there are no permanent H or V lines, it's all very dynamic, and it seems fixable to me.
Pretty much everything inside appears to be branded Sharp.
Thanks!
It powers up, and seems to respond to commands. the problem is the on-screen image is pretty scrambled. when I power up with no input, I see boxes where the menus should be, but they are crazy looking. ( see attachment, for what would be the "no video input" message.)
Feeding an input gives me a full screen of out-of-sync looking madness.
pressing the menu button in this case changes the whole screen to blue-ish out of sync looking stuff- exiting the menu, goes back to the other state. It seems to obey the remote and act normally otherwise..
Could this be a t-con, main board or power supply cap problem?
I've ruled out the display itself as there are no permanent H or V lines, it's all very dynamic, and it seems fixable to me.
Pretty much everything inside appears to be branded Sharp.
Thanks!
Attached Files
Comment