va26lhdtv10t vizio

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • bobbyd40
    Senior Member
    • Dec 2012
    • 116
    • usa

    #21
    Re: va26lhdtv10t vizio

    I took panel out because i noticed with panel laying face down and looking at front of it something in screen that looked like glass shards took apart to get at them to see what it was ,it was glass shards from edges of panel.

    probably why it went to white screen

    Comment

    • jharvey58
      New Member
      • Apr 2013
      • 3
      • usa

      #22
      Re: va26lhdtv10t problem

      I am also trying to fix a vizio VA26LHDTV10T. I have located a broken component (smd capacitor ??) on the lcd board in picture. ((I have no camera available, so borrowed a pic from bobbyd40's post to show what I am talking about.)) It is CP31. I need to find out if it is indeed a capacitor and what the specs are for replacing it.
      I experience loud snapping sounds from speakers and black screen upon powerup. If I disconnect the lcd ribbon from main board, sound stops and powers up to white screen.
      any ideas???
      Attached Files

      Comment

      • budm
        Badcaps Legend
        • Feb 2010
        • 40746
        • USA

        #23
        Re: va26lhdtv10t vizio

        CP31 is a cap, it is also conNected in parallel with CP30. Why do you think it is bad? does it show <1 Ohm resistance reading?
        Never stop learning
        Basic LCD TV and Monitor troubleshooting guides.
        http://www.badcaps.net/forum/showthr...956#post305956

        Voltage Regulator (LDO) testing:
        http://www.badcaps.net/forum/showthr...999#post300999

        Inverter testing using old CFL:
        http://www.badcaps.net/forum/showthr...er+testing+cfl

        Tear down pictures : Hit the ">" Show Albums and stories" on the left side
        http://s807.photobucket.com/user/budm/library/

        TV Factory reset codes listing:
        http://www.badcaps.net/forum/showthread.php?t=24809

        Comment

        • jharvey58
          New Member
          • Apr 2013
          • 3
          • usa

          #24
          Re: va26lhdtv10t vizio

          sending new pics (taken by phone) showing broken capacitor. Pretty obvious that it is no good.
          any ideas why I am getting the feedback noise through the speakers?
          Attached Files

          Comment

          • budm
            Badcaps Legend
            • Feb 2010
            • 40746
            • USA

            #25
            Re: va26lhdtv10t vizio

            When the MLCC cap is cracked, it will short out. So use the Ohm meter to find out if it is showing short or not.
            Disconnect the LVDS (FLAT cable) cable between the screen and the main board, then the TV should function normally with sound, you just will not have picture on the screen, you just see glowing screen.
            Never stop learning
            Basic LCD TV and Monitor troubleshooting guides.
            http://www.badcaps.net/forum/showthr...956#post305956

            Voltage Regulator (LDO) testing:
            http://www.badcaps.net/forum/showthr...999#post300999

            Inverter testing using old CFL:
            http://www.badcaps.net/forum/showthr...er+testing+cfl

            Tear down pictures : Hit the ">" Show Albums and stories" on the left side
            http://s807.photobucket.com/user/budm/library/

            TV Factory reset codes listing:
            http://www.badcaps.net/forum/showthread.php?t=24809

            Comment

            • jharvey58
              New Member
              • Apr 2013
              • 3
              • usa

              #26
              Re: va26lhdtv10t vizio

              you are very correct. I have previously disconnected the cable and found what you describe. Last night I replaced the cracked cap and set is now working properly.
              So, after 3 bad caps on the power supply (1000uf, 35v) and one on the T-con board, I have a working tv. Thanks for all the info and help. Hope others can benefit from my bad t-con cap problem.

              Comment

              • budm
                Badcaps Legend
                • Feb 2010
                • 40746
                • USA

                #27
                Re: va26lhdtv10t vizio

                Great job, thanks for repair feedback.
                Never stop learning
                Basic LCD TV and Monitor troubleshooting guides.
                http://www.badcaps.net/forum/showthr...956#post305956

                Voltage Regulator (LDO) testing:
                http://www.badcaps.net/forum/showthr...999#post300999

                Inverter testing using old CFL:
                http://www.badcaps.net/forum/showthr...er+testing+cfl

                Tear down pictures : Hit the ">" Show Albums and stories" on the left side
                http://s807.photobucket.com/user/budm/library/

                TV Factory reset codes listing:
                http://www.badcaps.net/forum/showthread.php?t=24809

                Comment

                Related Topics

                Collapse

                • howardc64
                  A1312 (27” iMac 2009-2011) A1407 (Thunderbolt Display) A1316 (Cinema Display) Display Black Screen Repair
                  by howardc64
                  Problem

                  This is an LG edge LED lit LCD Display. The LEDs are on the bottom edge of the display. There are 2 bars (left and right) Each bar has many LEDs and a 6 pin connector. Each pin drive several LEDs thus is the highest current flow / heat junction. The weak lead free solder gradually fails with thermal expansion/contraction cycling and increases resistance. PSU will compensate up to a point, then when the current is too high, PSU just shut down the backlight causing a dark display. I have even seen one which the connector just fell off as solder points became completely detached....
                  08-04-2024, 10:36 PM
                • Dani_2024
                  Sceptre U550CV-UMR 4K LED, Bad Caps on Main Power Board?
                  by Dani_2024
                  Hi and thanks in advance for any input you might provide!
                  I have a Sceptre U550CV-UMRD8POTV83BB 4K LED (this is a dumb tv) that I bought new in August 2021, so It's just completed 3 years.
                  Main power board model: TP.MS3683.PC821 T-Con board: N4TP546UHDPU2L_BO

                  Last Sunday I was watching a dvd and fell asleep for about half hour, when I awoke the tv screen was black and couldn't get the dvd menu to show, so I changed the input to antenna and had sound but no picture, turned it off. I then got online and found this great site! ....read many troubleshooting tips and this...
                  10-28-2024, 05:06 PM
                • jb_Bak
                  Sony xbr-65x900c main board issues?
                  by jb_Bak
                  Hey guys great forum glad to have found it. I bought a Sony XBR 65X900C cheaply because it didn't work. No signs of life at all not even a light/led. All I hear is a brief high voltage sound when I throw the power to it.

                  Didn't see any obvious signs of damage so right away started checking voltages. This is what I see:
                  Power Board Connector that goes to Main board
                  CN6401
                  Pin 01 NC
                  Pin 02 NC
                  Pin 03 "BL_ON": 0V
                  Pin 04 "N/C"
                  Pin 05 "STBY 3.3V": 3.5V
                  Pin 06 "GND": N/C
                  Pin 07 "AC_OFF"...
                  09-27-2021, 04:52 PM
                • JDC
                  (SOLVED) - ONN 100012588 No Power, Then Rebooting After Main Board Change
                  by JDC
                  ONN 100012588
                  Issue: No Power, Then Rebooting After Main Board Change

                  Short answer: replace main board and power board
                  Technical answer: replace main board and Q306 & Q307 on power board.

                  Long answer:

                  TV wouldn't turn on. Power switch was fine which means the main board isn't processing the power on signal. Replaced main board. TV turns on now but randomly reboots. Bad main board? EEPROM? Tried to pull main board and got a shock touching the corner of the board. That's weird. C334 (450V 10uf) capacitor is still holding a high charge....
                  07-15-2022, 07:39 AM
                • m1ch43lzm
                  HP Pavilion 15-eh Board DAG7HAMB8F0 - CPU throttling to 0.4GHz (PROCHOT_EXT) and black screen
                  by m1ch43lzm
                  Hi, this is my personal laptop, which the original board (lets call it Board A) blew up PU8700 (TPS51486), making a hole on the board, i had left the laptop at my desk one day with the battery fully charged and didn't touch it for a week, but when i tried to turn it on it didn't
                  Thought the battery was dead, so i plugged in the charger then tried to power on, the power LED blinked once, charged LED still orange, unplugged the charger, plugged in again and I noticed the "magic smoke" smell, so i unplugged the charger, removed the back cover and saw the blown IC (the "magic...
                  05-12-2025, 08:37 PM
                • Loading...
                • No more items.
                Working...