Announcement

Collapse
No announcement yet.

Westinghouse SK-32H240S - blue light, wont turn on

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    #21
    Re: Westinghouse SK-32H240S - blue light, wont turn on

    Brand new to this site. I have one of these sets that I haven't looked at in a while, but will get back into it now that I have found this thread.
    Phil

    Comment


      #22
      Re: Westinghouse SK-32H240S - blue light, wont turn on

      check the voltage regs and the fuses and diodes on the inverter board the vr's usually fail.common in westinghouse brands

      Comment


        #23
        Re: Westinghouse SK-32H240S - blue light, wont turn on

        Thought I'd add to this post. I have this model and here's what I've been told.
        On the main power supply circuit board you should see 3 inverter transformers, (look like little gray bars.) These are nortious for going bad. My unit would turn on and then there would be no picture and no sound. My set now has a cracked screen due to shipping with UPS which looks like a spider web accrossed it. But again I'm told this is usually the case with this t.V.
        Last edited by Dblueman; 02-03-2013, 07:12 PM.

        Comment


          #24
          Re: Westinghouse SK-32H240S - blue light, wont turn on

          I will do that awyatt2.
          just checked the electrolytic caps and all are good.
          thanks
          Phil

          Comment


            #25
            Re: Westinghouse SK-32H240S - blue light, wont turn on

            i have the same problem, have you got anywhere with this? same tv as well.

            Comment


              #26
              Re: Westinghouse SK-32H240S - blue light, wont turn on

              Yeah this tv are known for the inverters burning out. I replace two of this tv with new inverters.

              Comment


                #27
                Re: Westinghouse SK-32H240S - blue light, wont turn on

                I have the same problem in the CN200 connector I have all voltages
                Pin 22 of CN200 have 5 volts,
                the primary side large filter cap has 400V DC When TV is turn on t 140v before turning

                any brightness is seen on the screen

                Comment

                Working...
                X