JVC lt-47x579 backlight comes on but nothing else

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • tom66
    EVs Rule
    • Apr 2011
    • 32560
    • UK

    #21
    Re: JVC lt-47x579 backlight comes on but nothing else

    If you remove it, the set should power on normally with a good picture.

    I couldn't find the exact part in quantities any less than 3,000. You might have to see if the TV does get upset without it. Maybe different voltages are or eBay could be a source.
    Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
    For service manual, schematic, boardview (board view), datasheet, cad - use our search.

    Comment

    • JC1979
      Member
      • Jul 2012
      • 17
      • canada

      #22
      Re: JVC lt-47x579 backlight comes on but nothing else

      Ok, thanks. I will remove it and see how it goes.

      Comment

      • JC1979
        Member
        • Jul 2012
        • 17
        • canada

        #23
        Re: JVC lt-47x579 backlight comes on but nothing else

        Ok, so i took the board into an electronics shop that i have dealt with before, i had them remove ic2502. came home put the board back in, plugged everything in. hit power and nothing. I have the blue standby light on, but if i hit power on the tv or remote it does nothing. Any suggestions?

        Comment

        • RON_CET
          Badcaps Veteran
          • Jun 2012
          • 217
          • USA

          #24
          Re: JVC lt-47x579 backlight comes on but nothing else

          So your saying now you don't even get the backlight glow you had before?If so and your sure you have all connectors properly seated,then possible the design of the micro on that board if it don't see any type of voltage reset will not allow unit to boot up,which means your going to have to install that IC you removed with the part number from post#15
          Last edited by RON_CET; 07-20-2012, 03:07 PM.
          Ron Driver,BSEE,CET,ISCET,NESDA

          Comment

          • JC1979
            Member
            • Jul 2012
            • 17
            • canada

            #25
            Re: JVC lt-47x579 backlight comes on but nothing else

            Ok, ive looked and cant find it in quantities less than 3000. anyone out there know where i may be able to get one of these. Im willing to even change the whole board if need be at tnis point, but i cant seem to find one of those in stck anywhere either. Anyone out there have any sources tnat may be able to find either the part or the whole board.

            Comment

            • tom66
              EVs Rule
              • Apr 2011
              • 32560
              • UK

              #26
              Re: JVC lt-47x579 backlight comes on but nothing else

              I've done some cross-referencing and found this part to be an equivalent substitute:



              Farnell have it at £0.33 in single quantities, and in the 2.7V range, which is *probably* close enough.

              http://uk.farnell.com/jsp/search/bro...D2031%2B203653

              I just noticed it's out of stock but if you give them a ring they will get you a lead time and might even have a few left in stock.
              Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
              For service manual, schematic, boardview (board view), datasheet, cad - use our search.

              Comment

              • ben7
                Capaholic
                • Jan 2011
                • 4059
                • USA

                #27
                Re: JVC lt-47x579 backlight comes on but nothing else

                Originally posted by tom66
                I've done some cross-referencing and found this part to be an equivalent substitute:



                Farnell have it at £0.33 in single quantities, and in the 2.7V range, which is *probably* close enough.

                http://uk.farnell.com/jsp/search/bro...D2031%2B203653

                I just noticed it's out of stock but if you give them a ring they will get you a lead time and might even have a few left in stock.
                Do you think that he could go with a 3v one? Mouser has a 2.7v one but its on-order, they do have a 3v one in stock though.

                Edit: nevermind, thats still too close to 3.1v. Mouser does have a 2.5v one though!
                Last edited by ben7; 07-24-2012, 03:43 PM.
                Muh-soggy-knee

                Comment

                • tom66
                  EVs Rule
                  • Apr 2011
                  • 32560
                  • UK

                  #28
                  Re: JVC lt-47x579 backlight comes on but nothing else

                  Originally posted by ben7
                  Do you think that he could go with a 3v one? Mouser has a 2.7v one but its on-order, they do have a 3v one in stock though.
                  I think the 3V one is what caused the problem in the first place but it may work...
                  Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
                  For service manual, schematic, boardview (board view), datasheet, cad - use our search.

                  Comment

                  • ben7
                    Capaholic
                    • Jan 2011
                    • 4059
                    • USA

                    #29
                    Re: JVC lt-47x579 backlight comes on but nothing else

                    Originally posted by tom66
                    I think the 3V one is what caused the problem in the first place but it may work...
                    Mouser has a 2.5v one.
                    Muh-soggy-knee

                    Comment

                    • ITH
                      New Member
                      • Sep 2012
                      • 4
                      • mexico

                      #30
                      Re: JVC lt-47x579 backlight comes on but nothing else

                      hello, does it works?
                      i have the same issue and wanted to now if replacing IC 2502 is the solution
                      thanks in advance

                      Comment

                      • JC1979
                        Member
                        • Jul 2012
                        • 17
                        • canada

                        #31
                        Re: JVC lt-47x579 backlight comes on but nothing else

                        I will be honest. I never did order the part. The tv was in the spare room. Out of sigt out of mind. Well thanks to this reminder i just ordered the part and paid feo the expidited shipping so it should be here in a day or two. After i get it back together i will definitely post and let you know if it works.

                        Comment

                        • JC1979
                          Member
                          • Jul 2012
                          • 17
                          • canada

                          #32
                          Re: JVC lt-47x579 backlight comes on but nothing else

                          Ok. So the part came in today. Took it to guybi was going to get to solder it and first question he had was which way does it go? I showed him the picture posted by RON_CET here https://www.badcaps.net/forum/showpo...8&postcount=17 and it still leaves me two ways of putting it on. In the picture it shows one of the little prongs blacked out. any help would be apreciated. Thanks.

                          Comment

                          • tom66
                            EVs Rule
                            • Apr 2011
                            • 32560
                            • UK

                            #33
                            Re: JVC lt-47x579 backlight comes on but nothing else

                            There will be one slightly thicker lead on that device that lines up with the black pin.
                            Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
                            For service manual, schematic, boardview (board view), datasheet, cad - use our search.

                            Comment

                            • JC1979
                              Member
                              • Jul 2012
                              • 17
                              • canada

                              #34
                              Re: JVC lt-47x579 backlight comes on but nothing else

                              Perfect. Thanks tom. Will get her all put back tomorrow and will let you know how it goes.

                              Comment

                              • Ionized
                                New Member
                                • Nov 2013
                                • 1
                                • USA

                                #35
                                Re: JVC lt-47x579 backlight comes on but nothing else

                                Originally posted by JC1979
                                Perfect. Thanks tom. Will get her all put back tomorrow and will let you know how it goes.
                                Has this ever been resolved? I have the same model doing the same thing. The VReg readings I get are 2.48 VDC & 3.25 VDC (legs 1 & 3). Is there a test for IC 2502?

                                Comment

                                • JC1979
                                  Member
                                  • Jul 2012
                                  • 17
                                  • canada

                                  #36
                                  Re: JVC lt-47x579 backlight comes on but nothing else

                                  No. Never got it working. Had it soldered on. Didnt work so the set is now sitting behind a dresser In my spare bedroom. If you ever figure it out let me know.

                                  Comment

                                  Related Topics

                                  Collapse

                                  • triplefour
                                    UN65TU700DF picture and sound but no backlight. BL tests ok but repl. PSU didnt fix!
                                    by triplefour
                                    this tv is throwing me for a loop. do samsung tvs no longer have the backlight self test feature built into the power supply?
                                    i tested the backlight with my LED tester and it lights up both strips. one of them reads 100v and the other reads 63.7v.
                                    unplugged mainboard from power supply but left backlight plugged in, and then plugged psu wall power in. expected to see backlights light up but see nothing.
                                    according to how ive diagnosed in the past, this would almost always be a bad power supply. replacement power supply was cheap like 20$ from ebay. but still i get not even...
                                    09-13-2023, 10:43 PM
                                  • DanPoka
                                    Guide me through repairing a Dell p2210f LCD ccfl backlight monitor
                                    by DanPoka
                                    I bought this p2210f dell monitor to fix. Schematic is the same as p2210.
                                    Behaviour is that monitors comes on but then backlight switches off almost instantly. If I look with flashlight I can still find the "No signal message". So definitely a backlight issue. Trying to advance the issue I proved that the protection circuit is switching off the backlight by shorting out C3 and resistor to disable the INL chip then re enable by removing the short.
                                    This is where it gets interesting. When I disassembled the monitor to solder leads on c3 capacitor I noticed the backlight flickered...
                                    02-15-2025, 05:05 AM
                                  • Comp_Pro
                                    No Backlight Macbook A1990 820-01041
                                    by Comp_Pro
                                    Hello all,

                                    Am trying to figure out this backlight issue with this A1990 Macbook Pro.

                                    Tests performed:

                                    There is no backlight even with a good screen.
                                    Backlight IC is receiving the correct support voltages.
                                    Fuse F8400 ok
                                    Current sense resistor R8400 ok
                                    Backlight IC is receiving 3.3V on enable pin.
                                    Backlight IC receiving voltage from PPBUS_G3H, aprox 12.5V.
                                    Backlight IC receiving 5V from PP5V_G3S
                                    Backlight IC BKLT_SCL and BKLT_SDA both measure 0.545V diode mode to ground
                                    I2C_BKLT_SCL and I2C_BKLT_SDA both measure...
                                    05-06-2024, 10:23 PM
                                  • cheebster
                                    iPad Pro 12.9 5th Gen Backlight Issue
                                    by cheebster
                                    Hello, got an iPad Pro A2378 12.9 5th gen with no backlight. Got another test unit without screen, tested the screen, still no backlight with the test unit.
                                    Figured out the backlight on the screen was bad, ordred a new backlight from mobilesentrix, *carefully replaced it* without damaging the lcd, oh well.
                                    Final result, issue is still there, the screen has no back lights. So i'm back to square one, with 3 hours less and 100$ out, issue still on the screen.
                                    The panel is still ok, i can see the apple in the middle of the screen when it kicks in, just no backlight.
                                    Anyone...
                                    05-20-2025, 09:17 AM
                                  • canadaboy25
                                    LG Flatron 24EN33TA No Backlight When Cold
                                    by canadaboy25
                                    Hi all,

                                    I've got an LG Flatron 24EN33TA with a backlight issue. The problem began with the monitor not powering up after sitting for a long time (overnight or during the day throughout work). When I would wake the computer up, the backlight would flick on for a second then go out. Sometimes it would take many tries to get it to come on. Once the monitor came on, it worked flawlessly until another long duration of being powered off.

                                    I thought the problem would be bad caps but I checked both of the caps on the board and they are fine. I also tried powering the monitor from...
                                    03-07-2023, 12:23 AM
                                  • Loading...
                                  • No more items.
                                  Working...