lg 65uh5500

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Jason616
    Senior Member
    • Sep 2016
    • 99
    • United States
    #1

    lg 65uh5500

    Does this line mean the tv has a bad panel ?

    I've tried swapping ribbon cables and pressing on the ribbon cables that are glued to the circuit board with no change
    Attached Files
    Tags: None
    • Storyteller12
      Badcaps Veteran
      • Jun 2020
      • 624
      • USA
      #2
      Re: lg 65uh5500

      Yes. Most likely

        Comment

        Previous template Next

        Related Topics

        Collapse
        • Tr0ll
          T-con suspect issue. Both ribbon cables no picture. One ribbon cable ok. (58pus8545)
          by Tr0ll
          Hi guys! I realized you have a lot of knowledge here so i am hoping you could point me in right direction with my odd issue.

          The Tv is a Philips 58PUS8545/12, it had no picture but working backlights.

          Original T-con:
          Opened the Tv and tested to unplug one ribbon cable at a time. With this test i could see that i got fine picture on both halves as long as there was only one ribbon cable connected, with two connected picture were gone.

          First replacement T-con:

          I thought it might be t-con and ordered new t-con from china(supposedly tested)...
          10-07-2023, 07:48 PM
        • scubacamper
          Sharp Aquos LC-70C6400U Half Screen Dark
          by scubacamper
          I found another post on this site the other day which has been very helpful in troubleshooting this issue I am having with my tv. The left half of the screen is dark, and the other half is VERY slow to generate it's image - and it only generates part of its image at that.
          Based on this yt video, I have narrowed it down to an issue (short?) on the left side of the display, somewhere in the system of ribbon cables.
          when I remove the bezel and the rear cover, I can get the image to display correctly by manipulating the ribbon cables on the left side which connects the left lower display...
          https://youtu.be
          05-03-2025, 12:19 PM
        • Rubenlily
          Quick question about the ribbon
          by Rubenlily
          Hey,

          So I have horizontal lines on my TV and I'm trying to trouble shoot. My question about the ribbon is:

          When I disconnect one ribbon from the t-con I should get half picture working and other half black or something like that correct? But when I disconnect the ribbon on one side I just get a dark screen and it doesn't matter what side I disconnect. I just get the dark screen. No half working, no one half black and the other one left. Sound is playing from the TV so it's obviously on and when both sides are connected I have the picture with the horizontal lines...
          08-17-2023, 11:09 AM
        • Kiberge
          Samsung LH82QENELGC/EN Help needed - Static line on screen
          by Kiberge
          HI guys!

          I've got a Samsung LH82QENELGC/EN with a problem and need some advice and I hope this is the forum to use?
          I'm from Norway so I'd like to apology in advance if my description of the fault is kind of simple or the names on the components are way off. 😊

          the TV is powering up, working as normally and picture is all good, except a 1.5-inch-wide vertical line of snow/static across the screen.


          This TV is a Signage Display/Public Display version and it's been used at my work for 4-5 years showing commercials 24/7. The fault occurred when...
          04-22-2024, 11:28 AM
        • lowteq
          Partial Success Repairing Vertical White Bands on HP Z30i
          by lowteq
          Hello.

          I was given a HP Z30i LCD computer monitor that had several white wide vertical bands on it. I had another Z30i that was working and after a lot of swapping of components I found that the logic board, TCON board and associated ribbon cables were healthy. The problem was the ribbon cables that go from a long slender PCB across the top of the panel onto the panel itself. The problem connection was on the PCB side not the glass panel side. These ribbon cables are attached with some kind of heat set adhesive.

          I'm aware that this type of problem usually isn't repairable...
          03-27-2020, 10:49 AM
        • Loading...
        • No more items.
        Working...