Un55h6350afxza

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • jkb242
    Senior Member
    • Mar 2012
    • 175
    • USA

    #21
    Re: Un55h6350afxza

    Originally posted by lotas
    I did not mean to order from this site, I showed what part numbers should be for finding and ordering a motherboard.
    I was seeking assistance for a source as well since I haven't found any listed on Shop Jimmy or other providers I have used before. I just want to be sure that a replacement board would not require programming as I am unable to do this. Please advise. Thanks

    Comment

    • lotas
      Badcaps Legend
      • Jan 2016
      • 4542
      • Russia

      #22
      Re: Un55h6350afxza

      You can order a board with a smaller or larger diagonal size, let's say "50" and then change it to your panel in service mode, then look for the number BN41-02157B, the main thing is that the connector matches yours (LVDS), and that it matches your region.
      Attached Files

      Comment

      • jkb242
        Senior Member
        • Mar 2012
        • 175
        • USA

        #23
        Re: Un55h6350afxza

        I just saw the link you posted to my thread. I thought it was a recommendation as a source which I had requested, but then I read the reviews today after I ordered.

        WHY WOULD YOU POST A LINK TO A SOURCE TO ANOTHER MEMBER LOOKING FOR A SOURCE WITHOUT STATING A WARNING DONT GO THERE?

        If you did this intentionally I'm shocked that a member here would do this to another unsuspecting member.

        Comment

        • lotas
          Badcaps Legend
          • Jan 2016
          • 4542
          • Russia

          #24
          Re: Un55h6350afxza

          Originally posted by jkb242
          I just saw the link you posted to my thread. I thought it was a recommendation as a source which I had requested, but then I read the reviews today after I ordered.

          WHY WOULD YOU POST A LINK TO A SOURCE TO ANOTHER MEMBER LOOKING FOR A SOURCE WITHOUT STATING A WARNING DONT GO THERE?

          If you did this intentionally I'm shocked that a member here would do this to another unsuspecting member.
          I don't know anything about this site, I typed in the search and went to this site, so that you can see which numbers you need to pay attention to, and not order from this site.

          Comment

          • jkb242
            Senior Member
            • Mar 2012
            • 175
            • USA

            #25
            Re: Un55h6350afxza

            Originally posted by lotas
            You can order a board with a smaller or larger diagonal size, let's say "50" and then change it to your panel in service mode, then look for the number BN41-02157B, the main thing is that the connector matches yours (LVDS), and that it matches your region.
            Great info thanks. I suppose the board number you recommended was one that is more universal for this series and will accept the appropriate programming or paring with the exact TV configuration in which it would be installed. How is this done exactly, further reading you could suggest. I've ordered the exact replacement and trust no mod to the configuration is required.

            I did unknowingly purchase from a vendor who has been found by others here to be less than honest but the link was provide this thread with no warning! and Since I was requesting a source I took this as a link to a good vendor, naturally. . I just hope I'm lucky. I used PayPal so I would have “some” leverage in the event I encounter any issues. Bummer!

            Comment

            • jkb242
              Senior Member
              • Mar 2012
              • 175
              • USA

              #26
              Re: Un55h6350afxza

              Originally posted by jkb242
              Great info thanks. I suppose the board number you recommended was one that is more universal for this series and will accept the appropriate programming or paring with the exact TV configuration in which it would be installed. How is this done exactly, further reading you could suggest. I've ordered the exact replacement and trust no mod to the configuration is required.

              I did unknowingly purchase from a vendor who has been found by others here to be less than honest but the link was provide this thread with no warning! and Since I was requesting a source I took this as a link to a good vendor, naturally. . I just hope I'm lucky. I used PayPal so I would have “some” leverage in the event I encounter any issues. Bummer!
              My response to member nomoresonys was not intended to suggest you (Lotas) posted the link but somehow, my response to nomoresonys was directed to you which was not my intention. Very sorry that reply was apparently sent to you as it was not my intention to do so since you did not post that single link to this vendor.

              Comment

              • nomoresonys
                Badcaps Legend
                • Jan 2013
                • 12098
                • U.S.

                #27
                Re: Un55h6350afxza

                What are you smoking PAL? I didn't post a link to that site, Lotus did, before you start running your BIG MOUTH, try reading something when posted.

                Comment

                • jkb242
                  Senior Member
                  • Mar 2012
                  • 175
                  • USA

                  #28
                  Re: Un55h6350afxza

                  Lotas mention this site which I took as a reference location to see the board to which he referred in his explanation, you followed his post with a link containing the same vendor's name which I mistakenly took to appear as a recommendation. You obviously knew this vendor was not one to be recommended since you knew what complaints had been written.

                  Shame on me for not “catching” that link was to a warning but with everything in mind, you were careless not make this clear the link was to a warning. I'm not inferring you did this with intent to mislead but the seeing link alone was certainly not sufficient.

                  I admit I should have checked out the link to see it wasn't an endorsement. That was clearly my mistake. I have kept my comments direct and professional without personal insult. I don't believe that's too much to ask of you. Please see attached.




                  Attached Files

                  Comment

                  • jkb242
                    Senior Member
                    • Mar 2012
                    • 175
                    • USA

                    #29
                    Re: UN556350AFAZA

                    Update following system board replacement

                    Unfortunately no change but pursuing a couple follow on checks and requesting clarification on an earlier diagnostic testing.

                    -When removing one of display ribbon connections at the T-Con board with the power board connected to the system board, then applying AC power, I reported seeing the backlights turn on while viewing the rear panel and seeing a very dim backlight, across the screen, barely noticeable viewing the front of the display. Should the backlights be fully turned on at this point? The same question also applies to the other test with the power board disconnected from the system board. Why do the backlights turn on with either one of the T-Con to display ribbons connected but not both? Also, should there not be a viewable message of “no input” displayed on at least 1/2 the screen? Assuming there were video sources connected to the system board?

                    With the replacement system board installed and both boards connected normally, I also noted when AC power is applied, the standby LED blinks 6 times and extinguishes. Could this be due to the EEPROM having lost its programming or possibly being corrupt?

                    Much thanks for additional input.

                    Comment

                    Related Topics

                    Collapse

                    • m1ch43lzm
                      HP Pavilion 15-eh Board DAG7HAMB8F0 - CPU throttling to 0.4GHz (PROCHOT_EXT) and black screen
                      by m1ch43lzm
                      Hi, this is my personal laptop, which the original board (lets call it Board A) blew up PU8700 (TPS51486), making a hole on the board, i had left the laptop at my desk one day with the battery fully charged and didn't touch it for a week, but when i tried to turn it on it didn't
                      Thought the battery was dead, so i plugged in the charger then tried to power on, the power LED blinked once, charged LED still orange, unplugged the charger, plugged in again and I noticed the "magic smoke" smell, so i unplugged the charger, removed the back cover and saw the blown IC (the "magic...
                      05-12-2025, 08:37 PM
                    • Tynan Dill
                      Vizio e601i-A3 - Has Sound and Display, But No Backlight - Bad Power Supply Board or Bad LED Bulbs ?
                      by Tynan Dill
                      I was given this TV from my great uncle. He said it just wouldn't turn on one day out of nowhere, replaced the TV, and gave it to me to possibly fix and use for myself.

                      Upon bringing it home and plugging it up, it showed a standby light.

                      I powered it on and without a flashlight, the display showed the "V" but the lighting is very dim, but visible.

                      The screen seems to blackout and stay black, but with a flashlight I can see the display.

                      With my Playstation 4 connected via HDMI, and running a game I can hear sound.

                      Assuming...
                      11-22-2024, 01:46 PM
                    • Hakuu
                      LG OLED77G1PUA - No Video / Audio after a TCON Board change and Software Update
                      by Hakuu
                      Hi There,

                      This TV was auto switching off after few seconds with some vertical lines on the screen, so got a new TCON board and replaced it.

                      After replacing the TCON board it was working fine and i set it up with everything, used for few hours, then had the bright idea to update the software on it. During the update process, TV switched off and now no audio or video. No relay switch sound.

                      More Details

                      TV Model - LG OLED77G1PUA

                      Got the same exact TCON board from TVPartsToday and replaced it. But didnt transfer the EPPROM data (didnt...
                      07-12-2023, 02:37 PM
                    • jb_Bak
                      Sony xbr-65x900c main board issues?
                      by jb_Bak
                      Hey guys great forum glad to have found it. I bought a Sony XBR 65X900C cheaply because it didn't work. No signs of life at all not even a light/led. All I hear is a brief high voltage sound when I throw the power to it.

                      Didn't see any obvious signs of damage so right away started checking voltages. This is what I see:
                      Power Board Connector that goes to Main board
                      CN6401
                      Pin 01 NC
                      Pin 02 NC
                      Pin 03 "BL_ON": 0V
                      Pin 04 "N/C"
                      Pin 05 "STBY 3.3V": 3.5V
                      Pin 06 "GND": N/C
                      Pin 07 "AC_OFF"...
                      09-27-2021, 04:52 PM
                    • canadaboy25
                      Panasonic TC-P54VT25 No image. A or D board?
                      by canadaboy25
                      I have a Panasonic TC-P54VT25 that will power on and prime the display but there is no image at all.

                      The panel is primed as there is a slight glow from the entire panel. This means the problem should be logic related. The service manual also confirms this and recommends replacing the A or the D board.

                      I have tried to get the TV to display the test sequence but I have been unable to and I don't even know if this TV has a test sequence or not. I tried following tom66's instructions in post #3 on this thread https://www.badcaps.net/forum/showthread.php?t=26790. There was...
                      01-17-2021, 01:06 AM
                    • Loading...
                    • No more items.
                    Working...