Looking for MSI MS16P61 schematic and boardwiew, I made a short circuit trying to replace the screen while the notebook was still turned on, and now it doesn't turn on
-
I am trying to find two smd datasheets for an Apevia 1000w prestige power supply ATX-PR1000W the SMD's are ST9S313 which is a SMPS supervisory chip and a EST 915HP or XP48024 not sure which or both is the chp prod number and the schematic
-
Hello everyone,
I'm trying to repair my old Acer Nitro 5 (AN517-54-55T5). I've already bought a new laptop, so this is more of a learning project. For the experience, with no high expectations of success.
Well, my decice specs are the following:
Model: Acer Nitro 5 AN517-54-55T5
CPU: Intel Core i5-11400H
GPU: NVIDIA GeForce GTX 1650
Motherboard: GH51G LA-L181P Rev:1c
The symptom:
When pressing the power button, the power LED lights up for about 5 seconds and then turns off. Initially, the issue was intermittent: sometimes...05-26-2025, 10:49 AM -
since i couldn't find schematic or boardview for this model (LA-K062P), i use closest board model found here https://www.badcaps.net/forum/troubl...-and-boardview
the schematic share same marking for each component, using same PD-Controller, same BQ25710, the only different is the battery cell used. LA-K061P uses 3S battery while LA-K062P use 4S battery per schematic.
what i've done:
- flashing... -
Hello everyone, I come here in search of wisdom and hope.
I got this laptop with charging problems, apparently it charged ok while turned off but it would not charge while powered on, anyways I was doing initial measurements looking at the voltaje on the ID Pin, it is a 135W DC Adapter and the pin actually measured 1.9V that looks ok, anyways, while doing that, I accidentally shorted the ID pin DETECT(ID) with one of the 20V pins, sparkles and it automatically killed the TVS Diode PD102, and also made a cute burning hole on the middle of the KBC or EC chip UE1, it is a IT8227E-128... -
Hi guys, I'm working on a MSI Ventus RTX 4080 16G. The GPU has 12v, 5v, however what I assume is the 1.8v rail has 1.1v and what I assume to be PEX is 0v. As you may have guessed already there is no Vmem and no Vcore.
I have looked around in related forum posts for a schematic so Much appreciated if anyone can share a Broadview schematic.
Thanks.