Re: SAMSUNG NP700Z7C - BIOS dump needed
There is original, maybe corrupted:
There is original, maybe corrupted:
-
-
Re: SAMSUNG NP700Z7C - BIOS dump needed
Here
Techman1025Comment
-
Re: SAMSUNG NP700Z7C - BIOS dump needed
try this.Last edited by whaldsz; 04-04-2017, 11:28 PM.Comment
-
Re: SAMSUNG NP700Z7C - BIOS dump needed
Thanks for fast answer. Flashed with techman1025 dump now I have progres bar with Phoenix logo but stucked, can't enter into bios with F2 or F4. With whaldsz dump behaves same as original...
I think motherboard is bad??
There's pictures:Attached Filesif you find these attachements useful please consider making a small donation to the site
Comment
-
-
Re: SAMSUNG NP700Z7C - BIOS dump needed
Hi
Pull Cmos battery for a few min and hold power button down then plug adapter only and retry.
Techman1025Comment
-
Re: SAMSUNG NP700Z7C - BIOS dump needed
I tried it already...
Customer says that sometimes the start, after many attempts. The disc is correct, it is possible that the failure of the board ...Comment
-
Re: SAMSUNG NP700Z7C - BIOS dump needed
Hi
You could try a new bios chip and reprogram it with mine. Also try with only one memory stick in and do the same for the other socket see if it hangs so only one at a time you might have a bad stick of memory or a bad socket if one socket is bad double up on one socket is the only fix.
Techman1025Comment
-
Re: SAMSUNG NP700Z7C - BIOS dump needed
@techman1025
I tryed it also, one memory is soldered on the board and can't remove it. Also tryed with another bios chip...
@whaldsz
Nothing, same as other...
Anyway thanks a lot.
E.LelicComment
-
Re: SAMSUNG NP700Z7C - BIOS dump needed
Hi
What i would do is put some good flux under the onboard memory chip's and apply a little heat like 100C then retest if it works you could always replace them.
Techman1025Comment
-
Re: SAMSUNG NP700Z7C - BIOS dump needed
I tried to provoke him in the hot state, but nothing...
I think I'll give up.Comment
-
Re: SAMSUNG NP700Z7C - BIOS dump needed
I AGREE
Techman1025Comment
-
Re: SAMSUNG NP700Z7C - BIOS dump needed
NP700Z7C ba92 11017b dump maybe? accidentally erased the stock firmare before backup it first in my programer. I tried with last firmware whaldsz posted for BA92-10916B and only get backlight of the display and then he is restarting again and again and againComment
-
Re: SAMSUNG NP700Z7C - BIOS dump needed
Hello,
I need NP700Z7C BA92-10916A working bios, any chance someone have it?
It is stuck in samsung logo.
Here is the suspected not working dump.
ThanksComment
-
Re: SAMSUNG NP700Z7C - BIOS dump needed
Hello,
The solution to this Samsung Series machine is remove the dead iSSD flash from Sandisk. This cause a long freeze on boot.
I hope it helps.
BrAttached Filesif you find these attachements useful please consider making a small donation to the site
Last edited by xe_d_sono; 07-04-2020, 04:02 PM.Comment
-
It's Works
-
The Samsung S49CG934SU monitor does not power on - no LED indicator activity and no response to power button. However, when 21V power is connected, it immediately draws 0.8A of current with no display output. The motherboard processor gets warm, and there is continuous reading activity from the W25Q128BV BIOS chip.
Suspected Cause:
I suspect the BIOS may have been corrupted during a power interruption while updating the firmware. The official website provides firmware updates, but they can only be installed via USB flash drive.
Troubleshooting Attempts:
... -
Hi all,
My Samsung Galaxy Book 2 Pro 15.6-inch laptop has no display and won't boot.
The charging red LED lights up, but the charging screen doesn't show any indication.
When I press the power button, the blue LED cycles on and off three times, then the screen doesn't turn on, and the device won't boot.
(I've tried removing the battery and resetting the device, but the issue persists.)
NoteBook Model name : Samsung NT955XED-KK51G(Galaxy book2 pro, i5-1240p, 15.6inch AMOLED)
PCB model name : Venus2-15-5G(REV1.2), Venus2-15 ADL NPC
S/N : 5RNK9FFT70... -
Hi, I have an MSI PRO B660M-G DDR4 board with damaged BIOS and i need a bios dump from a real board, along with MAC, UUID and Serial Number info (eg. a BIOS screenshot and pictures from the board stickers).
I need to reconstruct the bios on my board, based on another bios image form a real board - meaning a bios image containing MAC address, UUID and Serial number. A stock BIOS is not suffiecient, as it is impossible to discover where the MAC, UUID and SerialNumber are stored. Tried with a similar board, but there are too much differences, and the stock BIOS is missing a lot of...11-17-2023, 10:56 AM -
Hi everyone,
I'm trying to recover a Fujitsu Lifebook E5513 (most likely 2023 model) that was bricked during a BIOS update. The update was interrupted (probably due to power loss), and now the laptop is stuck in a boot loop showing "PBB rollback" / "SBB rollback" messages.
BIOS access (F2) and Boot Menu (F12) are no longer possible – the system instantly reboots after the rollback messages.
I extracted the official BIOS update package from Fujitsu (contains FJNB2FD.CAP, ~18.7 MB) and tried tools like UEFIExtract, but it seems to only contain... -
After installing Linux, I can no longer enter the BIOS of my Samsung Series 9 (NP900X3C) laptop. When pressing [F2] during boot I simply get a black screen. Same thing when pressing [F10] and choosing "Setup" from the "App Menu" tab. Apparently this is a relatively common issue with Samsung laptops of that generation, but unfortunately i haven't been able to resolve the issue (yet).
Things i've tried so far; reinstalled Windows 10, checked for redundant boot entries, tried to factory reset using the emergency keyhole, attempted to clear the NVRAM by physically...08-01-2025, 09:15 AM
Comment