lenovo B40-30 MBD LA-B102P
I am facing a strange problem, this system is not turning on when it get complete dishcharge, neither with battery nor with plugin adopter, AND It also not turns on when I make it shut down and try to on after few hours. And when I unplug battery and again plugged in it will work normally battery also getting charge, and battery percentage is same as it was present during shutdown time
In case of without battery it will work normally and turns on every time.
what will be possible cause?
I checked physically there will be no any corrosion in battery section.
voltage on battery connector
@ pin 1,2 is 13.2v
@pin3 is 3.3v (EC_SMB_CK1)
@pin4 is 3.3v (EC_SMB_DA1)
@pin5 is 1.95v
THERE WILL BE NO ANY CHANGES IN THESE VOLTAGES WHEN I plugg charger.
I replaced battery and adopter too.
I am facing a strange problem, this system is not turning on when it get complete dishcharge, neither with battery nor with plugin adopter, AND It also not turns on when I make it shut down and try to on after few hours. And when I unplug battery and again plugged in it will work normally battery also getting charge, and battery percentage is same as it was present during shutdown time
In case of without battery it will work normally and turns on every time.
what will be possible cause?
I checked physically there will be no any corrosion in battery section.
voltage on battery connector
@ pin 1,2 is 13.2v
@pin3 is 3.3v (EC_SMB_CK1)
@pin4 is 3.3v (EC_SMB_DA1)
@pin5 is 1.95v
THERE WILL BE NO ANY CHANGES IN THESE VOLTAGES WHEN I plugg charger.
I replaced battery and adopter too.
Comment