Gateway NV59C09U No backlight LED

Collapse
X
Collapse
 
  • Page of 2
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
  • Reech
    Member
    • Sep 2012
    • 21
    • United States
    #21
    Re: Gateway NV59C09U No backlight LED

    I don't have the fine point test leads nor the skills to attempt those to probe those tiny little lands without frying the motherboard.
    Some of the larger areas, (fuses) were easier but.
    I could not understand much of the schematic, way too complicated for me.
    I am not very skilled at this level.
    Appreciate everyone's patience.

      Comment

      • lezsimply
        The Wanderer
        • Jan 2013
        • 645
        • Philippines
        #22
        Re: Gateway NV59C09U No backlight LED

        Look for needles used for sewing. They are usually thin and pointy, perfect for measuring components on motherboard. If you have spare probes modify it, solder those thin needles and wrapped it with electrical tape or something

          Comment

          Previous 1 2 template Next

          Related Topics

          Collapse
          • Document Archive
            Surface Mount Fuses Fundamentals Datasheet
            by Document Archive
            TE Circuit Protection offers the widest selection of surface-mount fuses available for addressing a broad range of overcurrent protection applications. Helping to prevent costly damage and promote a safe environment for electronic and electrical equipment, our single-use chip fuses provide performance stability to support applications with current ratings from .5A up to 20A.

            TE Circuit Protection also offers the telecom FT600 fuse for telecommunications applications. This telecom fuse helps comply with North American overcurrent protection requirements, including Telcordia, GR-1089,...
            10-07-2024, 06:07 AM
          • triplefour
            UN65TU700DF picture and sound but no backlight. BL tests ok but repl. PSU didnt fix!
            by triplefour
            this tv is throwing me for a loop. do samsung tvs no longer have the backlight self test feature built into the power supply?
            i tested the backlight with my LED tester and it lights up both strips. one of them reads 100v and the other reads 63.7v.
            unplugged mainboard from power supply but left backlight plugged in, and then plugged psu wall power in. expected to see backlights light up but see nothing.
            according to how ive diagnosed in the past, this would almost always be a bad power supply. replacement power supply was cheap like 20$ from ebay. but still i get not even...
            09-13-2023, 10:43 PM
          • DanPoka
            Guide me through repairing a Dell p2210f LCD ccfl backlight monitor
            by DanPoka
            I bought this p2210f dell monitor to fix. Schematic is the same as p2210.
            Behaviour is that monitors comes on but then backlight switches off almost instantly. If I look with flashlight I can still find the "No signal message". So definitely a backlight issue. Trying to advance the issue I proved that the protection circuit is switching off the backlight by shorting out C3 and resistor to disable the INL chip then re enable by removing the short.
            This is where it gets interesting. When I disassembled the monitor to solder leads on c3 capacitor I noticed the backlight flickered...
            02-15-2025, 05:05 AM
          • Comp_Pro
            No Backlight Macbook A1990 820-01041
            by Comp_Pro
            Hello all,

            Am trying to figure out this backlight issue with this A1990 Macbook Pro.

            Tests performed:

            There is no backlight even with a good screen.
            Backlight IC is receiving the correct support voltages.
            Fuse F8400 ok
            Current sense resistor R8400 ok
            Backlight IC is receiving 3.3V on enable pin.
            Backlight IC receiving voltage from PPBUS_G3H, aprox 12.5V.
            Backlight IC receiving 5V from PP5V_G3S
            Backlight IC BKLT_SCL and BKLT_SDA both measure 0.545V diode mode to ground
            I2C_BKLT_SCL and I2C_BKLT_SDA both measure...
            05-06-2024, 10:23 PM
          • cheebster
            iPad Pro 12.9 5th Gen Backlight Issue
            by cheebster
            Hello, got an iPad Pro A2378 12.9 5th gen with no backlight. Got another test unit without screen, tested the screen, still no backlight with the test unit.
            Figured out the backlight on the screen was bad, ordred a new backlight from mobilesentrix, *carefully replaced it* without damaging the lcd, oh well.
            Final result, issue is still there, the screen has no back lights. So i'm back to square one, with 3 hours less and 100$ out, issue still on the screen.
            The panel is still ok, i can see the apple in the middle of the screen when it kicks in, just no backlight.
            Anyone...
            05-20-2025, 09:17 AM
          • Loading...
          • No more items.
          Working...