I have a custom device with a shorted IP2315 ic. Looking for suggestions where to obtain a replacement, or an inexpensive donor device that contains that chip. IP2315 a USB-C battery controller made by Injoinic.
-
-
Re: Sourcing IP2315 IC
Just found this amazing item on AliExpress. Check it out! US $0.80 | IP2315 QFN32 100% New
https://a.aliexpress.com/_mKCIGwA -
Re: Sourcing IP2315 IC
Thank you. The shipping may take a while, and there are some concerns about whether it's a genuine IC. I was hoping one of the forum members might suggest an inexpensive donor contaning this IC that I could find locally. Anything that charges batteries via USB-C, like a flash-light, etc might have it.Comment
-
Re: Sourcing IP2315 IC
As a general comment, China will clone a popular component that will allow them to scam a larger customer base. Openly, do not see this component as a 'runner' so doubt that the part will be a fake. Rather, it is a less popular Asian brand of a controller IC. Lots of those out there. The tooling and startup costs to build a replica for such a small market does not make sense for them to do. Aliexpress has a few resellers of the part and perhaps consider to buy a few from each. We have had a very good success rate in seeking out replacement parts for service and/or building of new designs.
Select a vendor with a high customer rating to move forward. Just my 2 bit feedback.Comment
-
Hello everyone,
I am new into this, sorry to post it here. I want to make this as a pet hobby project, as this mac is not urgent.
I have (Macbook Pro 13inch 2017mid) A1706 820-00923-A
My mac had liquid damage a long time ago, the connector from J8500 is damaged on pin 46 (PP5V_S0_ALSCAM_F), I guess the LCD/display panel is in short circuit, as I saw the connector from the LCD burned as well.
And the resistor L4004 is literally burned.
From what I see from the schematics, it does not affect any other rails, only the connection to the display... -
I have Lenovo ThinkPad X1 Nano Gen 1 which is not charging on 1 usbc port (the one that has mark for charging).
When i connect usb it switchs to 20v but no current draw (only 0.02a) and orang light is on. In windows it shows that is charging but percentage is dropping.
Other usbc is charging fine,
I installed lates bios and firmwares for thunderbolt and battery.
Could be faulty JHL8040R controller?08-31-2024, 11:08 AM -
Hi guys.
Got a strange issue with a Dell 15 9510.
No liquid damage.
A client put it in the IT room for a year, boxed up. Now they come to use it and it's not working.
I put my USBC tester to it and it switches to 20v but is not drawing any current. 0 amps.
Nothing is shorted.
Any help is appreciated.
Thank you -
Is it possible to get it to post with just one USBC chip .....the bad one burnt and ruined pads below. I'm trying to get the data back
820-02020 M1... -
Hello friends, today i got an A2485 820-02100-A in a desd state, found visual short on PPVIN_5VUSBC23 line, removed tantalum capacitor, installed same same value from other donor board, now there is no short on any of the rails but when i plug either magsafe3 or usbc inget 5v stable with 0.00 amps drown, no cycle, just these steady values, board is not in dfu mode, checked with magsafe and with usbc. Only value that i find on the board is ppdcin_aon which is 5v… i dont get 3,3 aon, 3v8 aon .. all missing, where should i start looking please !...
Comment