Re: Sourcing IP2315 IC
Thank you. The shipping may take a while, and there are some concerns about whether it's a genuine IC. I was hoping one of the forum members might suggest an inexpensive donor contaning this IC that I could find locally. Anything that charges batteries via USB-C, like a flash-light, etc might have it.
technotech
New Member
Last Activity: 10-07-2023, 12:45 PM
Joined: 04-23-2013
Location: ca
-
Sourcing IP2315 IC
I have a custom device with a shorted IP2315 ic. Looking for suggestions where to obtain a replacement, or an inexpensive donor device that contains that chip. IP2315 a USB-C battery controller made by Injoinic. -
Re: JBC NT105-A Nano soldering handle
Yes, and it's out of stock -- it redirects to NT115-a. Thank you for trying to help.Leave a comment:
-
JBC NT105-A Nano soldering handle
I have a JBC Nano station that needs a new NT105-A soldering handle.
It looks like JBC no longer makes these -- any idea where to source one? -
Re: Antec NeoHE430 worth buying/recapping?
If it helps, I just finished re-capping the same model PSU with the parts from Digikey. While I've replaced all caps, the ones that measured bad were the following:
3300uf 10v
2200uf 10v
2200uf 6.3v
1000uf 6.3v
220uf 16v
22uf 50v (this one was somewhere on the primary side if I remember correctly).
Additionally, the main high voltage cap was slightly off in capacitance, but I probably could have kept it.
Following the recap the PSU is working great.Last edited by technotech; 01-19-2014, 09:52 PM.Leave a comment:
-
Re: Dell 2005FPW works for hours, but on hot re-boot fails...
Mine looked healthy, but were bad. You might want to just replace them anyways -- it shouldn't cost muchLeave a comment:
-
Re: Dell 2005FPW works for hours, but on hot re-boot fails...
How did you check the caps?Leave a comment:
-
Re: Dell 2005FPW works for hours, but on hot re-boot fails...
tasin, my caps looked fine physically (no bulging, leaks, color changes, or heat-shrink changes), but had high ESR.Leave a comment:
-
Re: Dell 2005FPW works for hours, but on hot re-boot fails...
Here's the problem I had with my Dell 2005FPW (solved):
Initially the monitor began making a high pitch noise for a minute or so coming out of stand-by. After a couple of weeks it got worse -- in addition to the noise it would blink power-led a few times before finally starting as if it couldn't get stable power.
I've tested all caps on the power board for capacitance, leakage and ESR. The only 3 caps that tested high ESR were the following:
c103 - 47mf 25v
c107 - 1mf...Leave a comment:
No activity results to display
Leave a comment: