Babystroller repair question

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Moreno83
    Badcaps Legend
    • Jun 2014
    • 2008
    • The Netherlands
    #1

    Babystroller repair question

    Hey Guys ,

    Has anyone ever tried to repair a baby stroller?
    Mine has gone defective , a part of the carrycot wont stand up anymore. The buttons are defective. Well the part inside ....

    I have not tried to open it ( there are no screws ) and i dont want to damage it.

    Anyone got any idea's? It's from the brand "kidsriver" but it could be coming from the same factory as bugaboo etc.

    Thanks.
    Attached Files
    I only repair Panasonic plasma tv's! Currently owning a TX-P55VT50 and still searching for a ZT60!
    Tags: None
    • Andrew F. Ali
      Badcaps Legend
      • Jan 2014
      • 2450
      • Trinidad & Tobago
      #2
      Re: Babystroller repair question

      Buy a new one.....Baby's safety most important...

        Comment

        • Moreno83
          Badcaps Legend
          • Jun 2014
          • 2008
          • The Netherlands
          #3
          Re: Babystroller repair question

          It is brand new but the last one and the one we wanted!

          It will be save , it's the "bow" or how do you say it that wont stay up. ( Protection from the sun ).
          I only repair Panasonic plasma tv's! Currently owning a TX-P55VT50 and still searching for a ZT60!

            Comment

            • stj
              Great Sage 齊天大聖
              • Dec 2009
              • 31094
              • Albion
              #4
              Re: Babystroller repair question

              brand new? get it replaced under the warranty.
              EU gives 2years minimum warranty.

                Comment

                • CapLeaker
                  Leaking Member
                  • Dec 2014
                  • 8226
                  • Canada
                  #5
                  Re: Babystroller repair question

                  Red Green would have put a little Duck Tape...

                    Comment

                    • goontron
                      5000!
                      • Dec 2011
                      • 4108
                      • US
                      #6
                      Re: Babystroller repair question

                      Originally posted by stj
                      brand new? get it replaced under the warranty.
                      EU gives 2years minimum warranty.
                      That also gets carried over to the US by some OEMs. At their discretion, obviously.

                      My brother had to warranty a stroller with his 3rd kid...
                      Things I've fixed: anything from semis to crappy Chinese $2 radios, and now an IoT Dildo....

                      "Dude, this is Wyoming, i hopped on and sent 'er. No fucking around." -- Me

                      Excuse me while i do something dangerous


                      You must have a sad, sad boring life if you hate on people harmlessly enjoying life with an animal costume.

                      Sometimes you need to break shit to fix it.... Thats why my lawnmower doesn't have a deadman switch or engine brake anymore

                      Follow the white rabbit.

                        Comment

                        • Moreno83
                          Badcaps Legend
                          • Jun 2014
                          • 2008
                          • The Netherlands
                          #7
                          Re: Babystroller repair question

                          It is fixed guys. I had to pull harder to get it in lock position. I was to carefull.....

                          Thanks anyways!
                          I only repair Panasonic plasma tv's! Currently owning a TX-P55VT50 and still searching for a ZT60!

                            Comment

                            Previous template Next

                            Related Topics

                            Collapse
                            • howardc64
                              A1312 (27” iMac 2009-2011) A1407 (Thunderbolt Display) A1316 (Cinema Display) Display Black Screen Repair
                              by howardc64
                              Problem

                              This is an LG edge LED lit LCD Display. The LEDs are on the bottom edge of the display. There are 2 bars (left and right) Each bar has many LEDs and a 6 pin connector. Each pin drive several LEDs thus is the highest current flow / heat junction. The weak lead free solder gradually fails with thermal expansion/contraction cycling and increases resistance. PSU will compensate up to a point, then when the current is too high, PSU just shut down the backlight causing a dark display. I have even seen one which the connector just fell off as solder points became completely detached....
                              08-04-2024, 10:36 PM
                            • Pize92
                              Defective BIOS chip
                              by Pize92
                              Hello everyone.
                              I have a problem.
                              The BIOS chip on my Lenovo Legion 5 17ACH6H appears to be defective. I wanted to read the chip first with the ch431a programmer and then with the t48 and create a dump. However, it always threw an error during verification.
                              I then bought a new BIOS chip from Aliexpress and loaded an existing dump onto the chip. With the corresponding DMI.
                              Unfortunately, the laptop now keeps restarting.

                              My question is, can you simply use the DMI from a foreign dump, or is the motherboard completely lost due to the defective BIOS chip?
                              08-19-2025, 10:59 AM
                            • rumpumpel1
                              How do I find a defective RAM chip
                              by rumpumpel1
                              I have a ThinkPad T14 which always finds an error at a very specific address during a RAM test. I therefore believe that exactly one of the RAM chips on the mainboard is defective. How do I find this defective RAM chip?
                              07-29-2025, 11:55 AM
                            • Patrick501
                              defective Embedded Controller MSI GF63
                              by Patrick501
                              Hello,

                              I located a defective EC (IT557VG-128)on a MS-16R81 2.0 board of a MSI Thin GF63 12U. The board doesn't have any voltages except the 19V power line.
                              Some Caps and resistors around the EC show less than 2 ohms. One of them is a 3V rail. When I inject 1V@1A the EC heats up.
                              I'm pretty sure I can't just buy and replace it since it probably needs the correct firmware on it.
                              Does anyone of you guys know?...
                              08-19-2025, 11:53 AM
                            • piernov
                              NVidia bumpgate
                              by piernov
                              Just archiving everything related to bumpgate since most stuff has disappeared from Google. Maybe people will finally take the time to read some of it and stop shouting "reflow gpu" at every occasion but rather try to understand what the real issue is…
                              Interesting parts about the failure analysis are "Why Nvidia's chips are defective" and "Why Nvidia's duff chips are due to shoddy engineering"


                              May complete this post at a later date with more details.
                              Basically issue is a combination of thermal dissipation of the chip with hotspot,...
                              03-27-2021, 10:34 AM
                            • Loading...
                            • No more items.
                            Working...