hey, this p4sd mobo from another hp d530 sff is giving me the 3 red flash, which according to its manual is the Processor not seated/installed error, of course the proc is seated and installed, and works (tested on other pc) so i was wondering if anyone could point me to which direction should i look for... given this specific error.
Due to the rush i didnot checked the status i recieved the mobo
i have also replaced the caps i found blown (not all the caps on the board, just those that looked bad)... if you think i should replace any other specific cap due to this failure, please advise, im up to hear any opinion. I also applied a little heat to the board and i dont know if that may have damaged it, what do you think?...
I suspect of tracks on the board, or some sort of passive element shortcircuited, maybe an IC.... and nothing seems wrong, like burnt and that, with the board...
so, whats on your mind? any tip or idea is highly appreciated.
thanks.
peace.
Due to the rush i didnot checked the status i recieved the mobo

i have also replaced the caps i found blown (not all the caps on the board, just those that looked bad)... if you think i should replace any other specific cap due to this failure, please advise, im up to hear any opinion. I also applied a little heat to the board and i dont know if that may have damaged it, what do you think?...
I suspect of tracks on the board, or some sort of passive element shortcircuited, maybe an IC.... and nothing seems wrong, like burnt and that, with the board...
so, whats on your mind? any tip or idea is highly appreciated.
thanks.
peace.
Comment