asrock h81m-vg4 rev 2.02

Collapse
X
 
  • Time
  • Show
Clear All
new posts

Related Topics

Collapse

  • pc.heidari
    Asus k550xv shut down after 30 minute
    by pc.heidari
    hi . k550vx motherboard x550vx rev 2 , i changed pch sr2c4 and power on .
    but 30 minute working fine and go shut down . i check bios and clean me region with some bios file but shut down after 30 minute . replace other pch but shut down . can you help me ?
    11-21-2020, 05:16 AM
  • gabrieljma1
    Request: Full BIOS dump for ASRock Z790-CX (DDR5)
    by gabrieljma1
    Hello everyone,

    I’m looking for a full raw 16 MB BIOS dump for an ASRock Z790-CX (DDR5) motherboard.

    The board powers on (fans spin, RGB lights on, RAM LEDs active), but there is no display output and the VGA and BOOT LEDs stay lit.
    I’m using an Intel i9-14900KF CPU (14th gen), and it seems the BIOS version on my board doesn’t support it yet. I tried to flash the official ASRock BIOS file (renamed .ROM → .BIN) directly using my RT809H programmer, but it didn’t work — monitor stays on but with black screen, so I believe the ASRock update file is not a complete...
    10-08-2025, 03:32 PM
  • hoarderteks_kyriakos
    Dell Latitude E5570 - No display, turns off after a minute of pressing the power button.
    by hoarderteks_kyriakos
    Hello.

    Yesterday my mother encountered a problem with her laptop, which led to it not turning on and expressing the behaviour mentioned in the title (you press the power button and then it turns off after a minute)

    Here is what happened:
    At one point i was fixing a setting on the laptop to make the laptop properly recognize the NVMe drive i put in months ago. All worked until all of a sudden the computer blue screened. The screen said it would reboot, but it never did. So she held down the power button, powering it off. Pressing it again, the screen briefly turned...
    10-08-2025, 07:33 AM
  • Exim
    ASRock N100M, no picture no boot, but semi-alive
    by Exim
    Hi guys,
    I managed to semi-kill an ASRock N100M board after updating Bios from 1.10 to 2.01. It's a zombie now, dead, but not dead.

    ASRock N100M special features:
    - CPU soldered to board, small Intel 12th gen
    - iGPU
    - four POST LEDs

    Problem after updating Bios to 2.01 using the in-Bios update tool: no picture, no boot.
    I am not sure anymore if it booted at least once successfully after updating the bios to 2.01, maybe not, I can't remember. I think it did not.

    Symptoms:
    - no picture/signal on any of the display connectors,...
    04-01-2025, 02:36 PM
  • MasterCap
    What IC does AsRock usually use to make the PWM signals for GPU fans ?
    by MasterCap
    I have an AsRock Taichi 7900xtx, and the minimum fan speed is way too high at 1000rpm, and thats with it's Quiet BIOS switch on, and me setting the fan profile as low as it goes, while on.

    Now 1 thing I could do is just make some circuit to put in between the fan the the GPU, and leave the fan on all the time, but anytime the GPU is sending the PWM for min speed, I'll just send something lower and quieter.

    But does anyone know what how AsRock usually sends the PWM to the fans on GPUs and mobo's? Is it from the MCU that's often near the 12V inputs and fan jack ? Or is...
    12-28-2024, 08:42 AM
  • Loading...
  • No more items.
Working...