My mobo a8v had some display issues, displaying some dots which I attributed for a bad driver or failing video card, but I continued to use it until it does not boot anymore. Only then I replaced the psu Antec, which still works, with a brand new one make Young Year & replaced the video card with another good AGP card as well as a PCI one but still no boot. Also replaced the memory card with other Kingston which I know is good but still no boot.
On power on the cpu fan & the power led works but there is no beep & no display on the vdu, even after trying several times.
The mobo has 6 * KZG 1500uf 6.3v caps but seems good, by looking at it as I did not remove it to test & I don't have an ESR meter either, although they are cathegorised to be bad caps & also 4 Nichicon 1000 uf 16v.
Will the board be ok if I replace only the 6 KZG only? or is there any other issues!
Also can I replace the KZG with Rubycon MBZ 2200uf 6.3v from an old abit ku8 mobo as in my island not sure I can get low ESR caps. The best that I seen are LXZ & some Rubycon YXG of 1000uf 16v.
On power on the cpu fan & the power led works but there is no beep & no display on the vdu, even after trying several times.
The mobo has 6 * KZG 1500uf 6.3v caps but seems good, by looking at it as I did not remove it to test & I don't have an ESR meter either, although they are cathegorised to be bad caps & also 4 Nichicon 1000 uf 16v.
Will the board be ok if I replace only the 6 KZG only? or is there any other issues!
Also can I replace the KZG with Rubycon MBZ 2200uf 6.3v from an old abit ku8 mobo as in my island not sure I can get low ESR caps. The best that I seen are LXZ & some Rubycon YXG of 1000uf 16v.
Comment