need to identify mosfet with marking "x01v 34"
it is for fan on 3d printer
it is for fan on 3d printer
-
-
-
Re: need to identify mosfet with marking "x01v 34"
Always better and faster with pictures ...please ..Comment
-
Re: need to identify mosfet with marking "x01v 34"
sorry guys i dont have it with me and custommer could not make close picture.
jiroy attach datasheet show exact marking
so thanks jiroy fo your help
Comment
-
Re: need to identify mosfet with marking "x01v 34"
Good luck
...
Comment
-
I tried to use this method:
Testing an N-channel MOSFET:
Step 1: Discharge the Gate (turn off the MOSFET)
Place the black probe (COM) on the Source (S) and the red probe on the Drain (D). The multimeter should show no continuity (high resistance or "OL" – open line).
Then, touch the black probe to the Source (S) and the red probe to the Gate (G). This discharges any stored charge in the Gate, turning the MOSFET off.
Step 2: Charge the Gate (turn on the MOSFET)
Now, place the red probe on the Gate (G) and the black probe on the...09-27-2024, 03:31 AM -
Hello all, as the title says, I'm very much in need of a valid firmware dump of a Anycubic Photon 5.5 3D resin printer. It's stored in a Winbond 25Q32, so it's 4Mbyte.
Here's a little background for my request. A few weeks ago I bought this 3D printer from a guy who had moved on to a PLA printer. I got it at a vey reasonable price, as it was in a defective state. The seller told me that he had experienced a power failure during a firmware upgrade, after which the printer appeared to be dead. He thought the firmware was corrupted in such a way that the printer was now bricked. As he... -
This mosfet is from surface 2 go and if i try power it on this is only component what is heating.cant find schematics to identify this mosfet so maybe someone can help?
Thanks... -
Hi Gentlemens,
Can any one please help identify this mosfet (power supply of CPU) from asus gaming laptop ? (ALA49EX)
one picture to show how it looks from bottom... -
Hello.
Have this HP 16-a0023nc DAG3JCMBCE0 that have burned mosfet on i think memory power. both memory modules shorted. after remove mosfets i measure 10ohm on that line which is low so after remove ic i have normal reading. But i cannot identify this ic. can...
Comment