I have a Cisco AP1252 that randomly won't come on and all three led's are solid red. I noticed that when I am heating up (hairdryer) the area where the 4 caps are located the AP has a much better success rate to start up (and working normally afterwards).
Even if I let it cool down for like half an hour it will still start sometimes.
The caps tested well (in circuit) with ESR meter - they are in parallel tho. As well no bulging or leaking.
So I am really not sure how to find the fault here. Bad solder joint? Caps?
Even if I let it cool down for like half an hour it will still start sometimes.
The caps tested well (in circuit) with ESR meter - they are in parallel tho. As well no bulging or leaking.
So I am really not sure how to find the fault here. Bad solder joint? Caps?
Comment