DELL 2408WFPB LCD Monitor

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • jacs
    New Member
    • Nov 2017
    • 5
    • Brasil

    #1

    DELL 2408WFPB LCD Monitor

    This LCD monitor have vertical lines all over the screen as you can see in the photos I posted here. They are quite different of the vertical lines I am used to and would like to know if anyone of you have experienced this same problem.

    No bad capacitor on the boards, at least visually. Should I remove all of them for testing off-board?

    Or do you think it could be the T-CON board?

    Thanks for any help.
    Attached Files
  • piernov
    Super Moderator
    • Jan 2016
    • 4435
    • France

    #2
    Re: DELL 2408WFPB LCD Monitor

    Try to reseat the LVDS cable and clean the connectors (on the mainboard and on the panel). If I'm right this is an issue with one specific LVDS channel (which is carried through one set of LVDS lines).
    OpenBoardView — https://github.com/OpenBoardView/OpenBoardView

    Comment

    Related Topics

    Collapse

    • Borse2008
      Seeking Advice: Repairing Dell U3425WE Monitor with Faulty USB-C/Thunderbolt Ports
      by Borse2008
      Hi everyone,

      Looking for some advice or opinions on what to do with a monitor issue I’ve run into. Apologies in advance is this crossovers a few forum categories.

      I have a Dell U3425WE, which I've recently replaced with another model. That said, the original unit is still fully functional in terms of the display — it works perfectly over HDMI and DisplayPort. However, the USB-C and Thunderbolt 4 ports have stopped functioning correctly. The Issue:
      • The 90W Thunderbolt 4 port (circled in the photo) no longer charges or powers any device, including laptops or MacBooks.
      • There’s
      ...
      07-15-2025, 04:55 AM
    • Jesus Coder
      Issues Reviving Old Dell 2408WFPb Monitor
      by Jesus Coder
      Hello everyone,

      I have been having some difficulties reviving an old Dell 2408WFPb PC monitor that I received for free. When I first acquired it, the backlights of the display were on but alas no image was showing. After extensive research on the topic, I went ahead and purchased a new t-con board for the monitor. After installing the board, I was then presented with a new screen that was half black and half green (more so black). I have been unable to figure out what to do next as I have limited knowledge of display electronics. Might anyone on this forum have an idea of what may...
      06-25-2023, 02:33 PM
    • DanPoka
      Guide me through repairing a Dell p2210f LCD ccfl backlight monitor
      by DanPoka
      I bought this p2210f dell monitor to fix. Schematic is the same as p2210.
      Behaviour is that monitors comes on but then backlight switches off almost instantly. If I look with flashlight I can still find the "No signal message". So definitely a backlight issue. Trying to advance the issue I proved that the protection circuit is switching off the backlight by shorting out C3 and resistor to disable the INL chip then re enable by removing the short.
      This is where it gets interesting. When I disassembled the monitor to solder leads on c3 capacitor I noticed the backlight flickered...
      02-15-2025, 05:05 AM
    • momaka
      HannStar Hanns-G HC194d LCD monitor repair
      by momaka
      Normally, I never post repairs this quick after I do them, because… I am usually very slow. But today, I’m making an exception here. Why? No idea. Perhaps only because the repair details are still “fresh” in my head… which is ironic, given this is a 16 year old monitor that hardly anyone will care about today. It is new to me, though. I picked it up last November from someone on my local Craigslist. It wasn’t very close to where I live, but was close to a family friend that I had to go visit anyways. So after watching the posting on Craigslist for a few weeks and seeing it getting...
      03-15-2023, 10:17 PM
    • reessi
      ACER BM320 Monitor - Horizonal Flickering Lines After a While
      by reessi
      Hello,

      The monitor started off showing flickering thin (1 pixel) lines horizontally every say 3mm..

      They are black on the right and gradually fade to nothing on the far left.
      They start either after 5 mins or up to 2 hours after so annoying for testing.
      They flicker continuously very fast! With a slight pause milli-second every second.

      Initially I cleaned the LVDS cable and connected to the T-Con and then it worked fine for 3 weeks but not sure if this was just co-incidence.

      I tested each half by removing the first the left flex from...
      06-03-2025, 09:58 AM
    • Loading...
    • No more items.
    Working...