This has got me puzzled with the following problem -
The set runs fine for 30-40 mins and then the display turns off and the green Power LED starts flashing. The self test screen then tries to start but almost immediately turns off. It then tries to start again but again almost immediately turns off. And so it goes on, in a continuous start/stop loop.
This happens on both inputs with different interconnect leads.
If it's left unplugged for a few hours once plugged in and switched on it will run again for about 30-40 mins before returning to the same off/on cycling.
Any ideas before I delve inside?
The set runs fine for 30-40 mins and then the display turns off and the green Power LED starts flashing. The self test screen then tries to start but almost immediately turns off. It then tries to start again but again almost immediately turns off. And so it goes on, in a continuous start/stop loop.
This happens on both inputs with different interconnect leads.
If it's left unplugged for a few hours once plugged in and switched on it will run again for about 30-40 mins before returning to the same off/on cycling.
Any ideas before I delve inside?
Comment