There was an issued with this board when I bought the monitor for repairs.
I replaced a 10uf 50v on c814 and a 47uf 25v on c807. I the got a picture on the monitor without backlamps on. (possible ccfl's' bad, no backups laying around atm) There was a clicking going on the board while the inverter was plugged in but I dont hear well anymore, so finding the location was difficult. Well, here is what happened. I got out the DMM and started probing around. Probing a Mosfet 4n60b sss s0220 while just checking for power I shorted pin 2,3 D,S I belive they are. Now thre isnt any power getting to the top half of the board. OUCH! Any pointers? What did I blow?
I replaced a 10uf 50v on c814 and a 47uf 25v on c807. I the got a picture on the monitor without backlamps on. (possible ccfl's' bad, no backups laying around atm) There was a clicking going on the board while the inverter was plugged in but I dont hear well anymore, so finding the location was difficult. Well, here is what happened. I got out the DMM and started probing around. Probing a Mosfet 4n60b sss s0220 while just checking for power I shorted pin 2,3 D,S I belive they are. Now thre isnt any power getting to the top half of the board. OUCH! Any pointers? What did I blow?
Comment