Re: Onkyo HT-R591 keeps clicking
First I want to properly measure the transformer. I have started removing it, but there are a couple of connectors with wires that are going all over the receiver, so I have to take apart, most of the boards to reach to those connectors.
Did not have enough time to do all of that.
It seems that all the pins/wires are coated and it's very hard to get a good reading. I will remove the transformer tomorrow, clean up a couple of conections and I will measure them and I will let you know.
I have disconnected the transformer from the rest of the receiver, except those ribbon cables that are coming out from underneath the output PCB and it was still clicking.
First I want to properly measure the transformer. I have started removing it, but there are a couple of connectors with wires that are going all over the receiver, so I have to take apart, most of the boards to reach to those connectors.
Did not have enough time to do all of that.
It seems that all the pins/wires are coated and it's very hard to get a good reading. I will remove the transformer tomorrow, clean up a couple of conections and I will measure them and I will let you know.
I have disconnected the transformer from the rest of the receiver, except those ribbon cables that are coming out from underneath the output PCB and it was still clicking.
Comment