Xiaomi Roidmi EVE Pro battery died!

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • CidiRome
    Member
    • Jan 2015
    • 49
    • Portugal

    #1

    Xiaomi Roidmi EVE Pro battery died!

    Hi there.

    I hope one of you may be able to help me.

    My Xiaomi Roidmi EVE Pro battery died.
    I disassembled the battery and tested the cells to find 2 dead and other 2 almost dead.
    I then dug some batteries from my notebook battery bucket and recovered 8 cells to rebuild the battery.
    Yet I can't get the BMS to start working again: the output is 0 Volts and it won't charge either.
    Did not try to put it in the robot yet, but I don't think the robot will reset the BMS...
    The current cell balance is good with a total voltage around 14.5V.
    Any Ideas?
    Attached Files
  • sam_sam_sam
    Badcaps Legend
    • Jul 2011
    • 6040
    • USA

    #2
    Re: Xiaomi Roidmi EVE Pro battery died!

    Try this do you have an adjustable power supply if so try slow bringing of the voltage from around 0 volts to around 10 volts or so and then see if it will charge you might have to limit the current because some BMS protection board are weird like that I have a few of them that if you go over 2 amps they play dead but if you limit the current to 500 to 1000 milliamperes they work fine

    The other possibility is that the voltage is a little to high and the BMS protection board is locked out

    Or you need the third wire to activate the BMS protection board although I have not run across one yet like that

    If that does not work then maybe that is why the battery are dead the original ones and the BMS protection bad
    Last edited by sam_sam_sam; 07-19-2023, 03:43 PM.

    Comment

    • CidiRome
      Member
      • Jan 2015
      • 49
      • Portugal

      #3
      Re: Xiaomi Roidmi EVE Pro battery died!

      Hello.

      Thank you for trying to help.
      It seems that the issue is this component that Sorin is referring to in this Video:
      https://www.youtube.com/watch?v=zVGD...ygUFZDZzYzQ%3D

      I will try to dig one from the battery bucket.

      Cheers.

      Comment

      • sam_sam_sam
        Badcaps Legend
        • Jul 2011
        • 6040
        • USA

        #4
        Re: Xiaomi Roidmi EVE Pro battery died!

        Thank you for sharing this information and the link to it this will help me a lot with attempting to repair BMS protection board issues

        Could you please show a picture of where this fuse is located on your BMS protection board
        Last edited by sam_sam_sam; 07-22-2023, 05:58 AM.

        Comment

        • eccerr0r
          Solder Sloth
          • Nov 2012
          • 8701
          • USA

          #5
          Re: Xiaomi Roidmi EVE Pro battery died!

          deleted, I posted to wrong thread

          Comment

          • CidiRome
            Member
            • Jan 2015
            • 49
            • Portugal

            #6
            Re: Xiaomi Roidmi EVE Pro battery died!

            Hello.

            Please check the attached picture.

            Hope it helps someone else.

            Cheers.
            Attached Files

            Comment

            • sam_sam_sam
              Badcaps Legend
              • Jul 2011
              • 6040
              • USA

              #7
              Re: Xiaomi Roidmi EVE Pro battery died!

              Originally posted by CidiRome
              Hello.

              Please check the attached picture.

              Hope it helps someone else.

              Cheers.
              Did you try to temporarily bypass the fuse and see if it comes back to life and functions correctly or not

              I would not recommend leaving with out the fuse if you plan on using this BMS protection board but just for testing purposes
              Last edited by sam_sam_sam; 07-24-2023, 04:29 AM.

              Comment

              • CidiRome
                Member
                • Jan 2015
                • 49
                • Portugal

                #8
                Re: Xiaomi Roidmi EVE Pro battery died!

                Hello.

                I know that it will work if I bypass it, because I get voltage in the cable if I short it with the tweezers.

                I ordered it to replace.

                Cheers.

                Comment

                • Amironox
                  New Member
                  • May 2024
                  • 1
                  • Israel

                  #9
                  I had the same issue with this battery after replacing two failed cells. It seems if voltage drops on BCM below certain level it blocks itself. No idea on how to unlock it. So I soldered down a thick wire to short a control transistor on the photo above, reassembled battery and put it back to vacoom. Two weeks gone, no issues. Battery level detected correctly, carging works fine also.

                  Comment

                  • Mersaine Mersaine
                    New Member
                    • Oct 2024
                    • 2
                    • France

                    #10
                    Hello, I think I'm facing a similar issue with my Roidme EVE plus. I changed the battery but my robot is still not working here are details information I posted on a Facebook post attached with photos and videos : https://www.facebook.com/groups/1374...40aB7S9Ucbxw6v roidme support tells me to replace the motherboard what do you think are my symptoms identical to battery failure could the 2nd battery ordered be falty ?

                    Here is the battery i ordered you can even see it in the photos.
                    Hello everyone,

                    I think I'm facing a similar issue with my Roidmi EVE Plus. I recently replaced the battery, but the robot is still not working. I've shared detailed information, including photos and videos, in this Facebook post: Facebook link: https://www.facebook.com/groups/1374...40aB7S9Ucbxw6v

                    Roidmi support is advising me to replace the motherboard, but I'm wondering if my symptoms are consistent with battery failure. Could it be possible that the replacement battery I ordered is also faulty?

                    Here's the battery I ordered : Just found this amazing item on AliExpress.
                    https://a.aliexpress.com/_EGMW4mZ

                    you can see it in the photos.

                    Any insights would be greatly appreciated!

                    Sincerely,
                    Mersaine

                    Comment

                    Related Topics

                    Collapse

                    • Bowline
                      Dell E6400 PT434 type Battery Charging Stuck at 1%. Battery Pinouts?
                      by Bowline
                      My question pertains to understanding the control circuity inside a Dell PT434 type battery used in Dell E6400, E6410 and other Dell notebooks?

                      Does anyone have a circuit diagram for the inside of a Dell PT434 battery and/or a description of how the control lines work to control this battery?

                      My reason for asking is I have a battery which I cannot get to charge beyond 1% in a Dell E6410 or E6400.
                      The LED bar graph charge indicator on the battery shows one LED lighted when the info button is pressed.
                      I have tried multiple different Dell power adapters. My Dell...
                      06-11-2025, 10:13 AM
                    • mkdj
                      ASUS X571 no power : battery issue?
                      by mkdj
                      Hello everyone,

                      Mark and model: ASUS X571
                      Symptoms: not turning on. There is only the LED battery indicator working. The owner of the laptop told me this problem arrived one week after having changed the battery. He then managed to power on the laptop only once, and then it never powered on again.

                      Tests already made:
                      - Battery is charging when laptop is plugged in. The LED battery indicator turns white after a couple of hours of charge, indicating that battery is fully charged. However, laptop won't turn on anyway, with or without AC plug.
                      - I have removed...
                      07-14-2025, 09:16 AM
                    • techfreak9356
                      Vostro 3400 (LA-K033P) won't charge battery, everything else ok
                      by techfreak9356
                      I bought a Vostro 3400 motherboard (LA-K033P) to upgrade over my damaged Inspiron 5593 (LA-J091P) board. Everything else is ok except for the battery. This battery I am using now is already a replacement one since I disposed of the bloated original one. Back in the Inspiron 5593 motherboard, the battery charges fine and is identified just fine. However, with the upgraded motherboard, suddenly the replacement battery is labeled as "Not a dell battery". When I borrow a similar battery from my colleague (which did not have replacements yet), it is identified and charges just fine.
                      ...
                      09-14-2023, 11:10 PM
                    • Document Archive
                      ISL88739AHRZ ISL88739 Laptop Battery Charger Datasheet
                      by Document Archive
                      The ISL88739 & ISL88739AHRZ are a highly versatile combo battery charger
                      configurable for operating as either a Hybrid Power Boost (HPB)
                      charger or a Narrow VDC (NVDC) charger, supporting 2-, 3-, or
                      4-cell batteries. Both configurations allow the battery to work with
                      the adapter together to supply the system load when it exceeds
                      the adapter capability, referred to as system Turbo mode. HPB
                      charger configuration reverse-boosts battery energy to the system
                      bus to help the adapter provide the system power in Turbo mode.
                      NVDC charger configuration...
                      11-05-2024, 03:28 PM
                    • ferah831208
                      Strange battery present behaviour in Lenovo Legion 5-15ARH05 mb model nm-d041
                      by ferah831208
                      Hello guys, i need help with this problem, I have a NM-D041 mobo, it came with low impedance in 3v linear regulator rail, the cause was a damaged EC controller ITE8227e-192. I ordered a new one and replaced it. This laptop have a different chip for keyboard management and it8227e pins for programming ITE chips are not accesible through keyboard interface, I flashed it using i2c interface pins with vertyanov programmer because laptop was dead and SPI flash didn't have power (only 3v EC) so it couldn't access firmware stored in SPI memory. I read SPI and extracted it8227 firmware from original BIOS...
                      03-18-2025, 01:18 AM
                    • Loading...
                    • No more items.
                    Working...