if a washing machine is said to be 6.5 Kg, what does it mean? Does it mean cloth load+ water or just cloth load. I'm asking this due to personal issue.. My washing machine max load is 6.5 Kg. When I try to wash my blanket, it weighs a lot when water is added (More than 6.5Kg) . Is it okay to wash such load on this machine machine?
-
Hello everyone,
I'm looking for a replacement for the red LEDs used in a Fisher & Paykel 10 kg top-load washing machine. Each LED is about 6 mm long, mounts flush to the PCB with side tabs, and measures around 1.7 V forward voltage in diode-test mode. The marking on the body is “3A56,” but I can't find any matches for that in part searches. I've attached photos to show the shape and mounting style.
If anyone has sourced an equivalent or knows a suitable replacement, I'd really appreciate your input. Thanks in advance for the help!... -
Hi everyone,
I am trying to fix a samsung washinmachine power supply main board.
I already replaced it with another one to fix the machine but i want to try understand the issue with the old board.
Therefore i hope to be able to get some help to explain what to check in order to troubleshoot.
The power supply board reference is the following: DC41-00189a
I have followed one thread (https://www.badcaps.net/forum/troubl...ingmachine-rel... -
I got a Asko washing machine that has had the flat ribbin cable sustain damage from some corrosion. I have tried to repair it but the ribbon cant sustain the repair and keep breaking. I was trying to source a new LED display but I cant figure out how to try and source one. the information on the back of the display is 13669-LED-A-A173-161007-RoHs. Its also a negative display witha 17v supply for the LED back light and the connectors are 26 pin x 2. What do i have to provide to try and source one of these?...
-
Hi,
This washing machine has power module emc18aecn1 and programmer ewx14931 914913208.
It stop after electric shock.
When i choose only spin it show 12min remaining. After 1min it start drain pump, after
second it start relay (measured 12v ot relay`s coil) that deliver 230V to power module.
This is also ~1second and then pump and relay stop. After ~2min this repeat - pump,
after it relay and both stop.
There is no error.
Can somebody help me to try to fix it? -
Hi Folks,
Just wanted to clear up a misunderstanding of mine (or what I expect is one). Isn't the 12V rail from the 24 pin, EPS and PCIE separated? IE if I put a power resistor on the ATX 12V pin that is not going to load, thus tell me if the EPS or PCIE rails are fine?
I was recently watching ArIs from Hardware Busters video on how to properly test ATX PSUs without using 5 figure Croma substations.
The PCB adapter he used breaks out the 12, 5 and 3.3V pins from the 24 pin and gives you banana plugs to connect to. That is a bit useless is it not? Aren't...
Comment