What size barrel jack is this?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • evilkitty
    Badcaps Veteran
    • Nov 2017
    • 299
    • USA

    #1

    What size barrel jack is this?

    I want to adapt this plug

    to this socket


    some time back i got a replacement charger for my laptop, i fixed the original, and this laptop uses the same power spec on a different jack size, so rather than buying a adapter i can just buy a adapter jack
  • diif
    Badcaps Legend
    • Feb 2014
    • 6978
    • England

    #2
    Re: What size barrel jack is this?

    That looks like it has a pin in the centre for sensing the power, a Dell ? It could be an HP but either way you will have to spoof the sensing. HP use resistors and Dell a chip.

    Comment

    • eccerr0r
      Solder Sloth
      • Nov 2012
      • 8701
      • USA

      #3
      Re: What size barrel jack is this?

      I think it's easier to just tell us the brand/model of the laptop and can work backwards from there. Hopefully it does not use a custom chip to supply.

      Dell
      Sony
      HP
      Lenovo

      Comment

      • evilkitty
        Badcaps Veteran
        • Nov 2017
        • 299
        • USA

        #4
        Re: What size barrel jack is this?

        It is a dell N5010, it calls for a 65W brick
        i did try it by bypassing the jack completely and it did work, i disabled the power adapter warning in the BIOS
        https://imgur.com/a/TrPhLmH
        will it just throttle the laptop without the sense?
        Last edited by evilkitty; 08-20-2020, 07:34 PM.

        Comment

        • eccerr0r
          Solder Sloth
          • Nov 2012
          • 8701
          • USA

          #5
          Re: What size barrel jack is this?

          as far as I know, it will simply charge slow or not charge at all if it can't ascertain the charger.

          Comment

          • evilkitty
            Badcaps Veteran
            • Nov 2017
            • 299
            • USA

            #6
            Re: What size barrel jack is this?

            as i have no battery, that is not really an immediate concern

            Comment

            • eccerr0r
              Solder Sloth
              • Nov 2012
              • 8701
              • USA

              #7
              Re: What size barrel jack is this?

              Well, the implication is that it could simply not power the CPU either, so throttling is indeed possibility... or simply shutdown...

              who knows what the firmware says...

              Comment

              • diif
                Badcaps Legend
                • Feb 2014
                • 6978
                • England

                #8
                Re: What size barrel jack is this?

                Using a non Dell charger on a Dell will mean it's throttled and won't charge the battery at all.
                It's fairly easy to make something to spoof the charger though. https://hackaday.com/2014/03/03/hack...dentification/

                Comment

                Related Topics

                Collapse

                • howardc64
                  A1312 (27” iMac 2009-2011) A1407 (Thunderbolt Display) A1316 (Cinema Display) Display Black Screen Repair
                  by howardc64
                  Problem

                  This is an LG edge LED lit LCD Display. The LEDs are on the bottom edge of the display. There are 2 bars (left and right) Each bar has many LEDs and a 6 pin connector. Each pin drive several LEDs thus is the highest current flow / heat junction. The weak lead free solder gradually fails with thermal expansion/contraction cycling and increases resistance. PSU will compensate up to a point, then when the current is too high, PSU just shut down the backlight causing a dark display. I have even seen one which the connector just fell off as solder points became completely detached....
                  08-04-2024, 10:36 PM
                • abajor
                  Methods for testing 3 pin Barrel jack PSU's?
                  by abajor
                  I'm getting pretty annoyed with the lack of options for testing HP, DELL, ASUS etc. Laptop PSU's the old 2 pin jacks were easier.

                  From what I understand the +V is on the internal barrel ring, and the control/sense voltage is on the center pin.

                  I was wondering if someone has made a laptop PSU load tester where technicians can easily scope and load these 3pin laptop PSU to see if it's failing?
                  09-14-2024, 04:29 PM
                • valvashon
                  Samsung UN55FH6030CXZA main board USB jack indentification
                  by valvashon
                  Samsung UN55FH6030CXZA main board, BN41-01894, bad USB jack. Jack is mangled and needs replacing with like. Jack is marked "Simula" with the number 130318. Search for Simula turns up a weak looking website of a company that seems/seemed to supply USB jacks and other USB technology but no current items turn up for sale.

                  I should be able to research and find something applicable through a Digi-Key search after I unsolder/cut out this one and measure the mounting/pin connection pattern on the board but I thought I'd ask here to see if anybody knows of an exact make/model...
                  01-23-2025, 11:17 AM
                • zman78
                  Screw-In Barrel Adapter for LED light array gets really hot?
                  by zman78
                  Hi All,

                  I have an LED Light array that had a built-in AC-DC 24v 45 watt power supply. The power supply failed so I desoldered the LED Light array power input wires from the power supply and then screwed it into barrel connector jack (ends still tinned with the original solder).

                  This is the barrel connect or jack https://www.amazon.com/gp/product/B07Q6YMM6F/

                  Then I bought an external 24Volt/3Amp power brick (with same size barrel connector output) and plugged it in.

                  Everything works fine, except that the screw-in barrel connector gets...
                  06-28-2021, 03:35 PM
                • dragometin
                  Hitachi 40HYC42
                  by dragometin
                  TV Model: Hitachi 40HYC42
                  Power Supply: 17IPS71
                  MainBoard: 17MB95M
                  Panel: VES400UNDS-2D-NO3

                  When the set came in it was dead. Fuse was open primary side and the power mosfet was shorted. So I ordered a new power supply. Now it turns on, only displays "Hitachi" and then power off red and blue led flashing.

                  I had to modify the 0ohm resistors in the led backlight of the new PS like the original power supply.
                  Is there any variants on 17IPS71 power supply's?

                  UART output pins 10 and 12 on scart connector:

                  Code:
                  12:24:04.595
                  ...
                  08-08-2024, 05:53 AM
                • Loading...
                • No more items.
                Working...