Re: What Are These Resistor Looking Componenets?
both resistors are connected to the source of each mosfet.
the + is output 1 from the transformer, connected to the gate of the mosfet that blew, then through a diode to the resistor that looked burnt but still reads within the tolerance found from my searching earlier. diode is still good as well. im thinking that it was just a bad fet.
the main cap that blew traces as a part of the output 2 from the transformer. (anode side) this is why i was initially thinking that the transformer went bad.
ive been searching for a spec sheet on the ic, naturally as its on a circuit path in a sense of a circuit that went south, but have yet to find what im looking for.
Originally posted by budm
View Post
both resistors are connected to the source of each mosfet.
the + is output 1 from the transformer, connected to the gate of the mosfet that blew, then through a diode to the resistor that looked burnt but still reads within the tolerance found from my searching earlier. diode is still good as well. im thinking that it was just a bad fet.
the main cap that blew traces as a part of the output 2 from the transformer. (anode side) this is why i was initially thinking that the transformer went bad.
ive been searching for a spec sheet on the ic, naturally as its on a circuit path in a sense of a circuit that went south, but have yet to find what im looking for.
Comment