Please find the enclosed picture. In the picture i identify an electrical part outlined with a red circle. Can someone tell me where i can get the data sheet for this part or a suitable replacement part?
Need help identifying replacement part
Collapse
X
-
Re: Need help identifying replacement part
CS830 N-CH MOSFET.
What is the board not doing?Attached FilesNever stop learning
Basic LCD TV and Monitor troubleshooting guides.
http://www.badcaps.net/forum/showthr...956#post305956
Voltage Regulator (LDO) testing:
http://www.badcaps.net/forum/showthr...999#post300999
Inverter testing using old CFL:
http://www.badcaps.net/forum/showthr...er+testing+cfl
Tear down pictures : Hit the ">" Show Albums and stories" on the left side
http://s807.photobucket.com/user/budm/library/
TV Factory reset codes listing:
http://www.badcaps.net/forum/showthread.php?t=24809 -
Re: Need help identifying replacement part
Just type in CS830 in the search engine.Never stop learning
Basic LCD TV and Monitor troubleshooting guides.
http://www.badcaps.net/forum/showthr...956#post305956
Voltage Regulator (LDO) testing:
http://www.badcaps.net/forum/showthr...999#post300999
Inverter testing using old CFL:
http://www.badcaps.net/forum/showthr...er+testing+cfl
Tear down pictures : Hit the ">" Show Albums and stories" on the left side
http://s807.photobucket.com/user/budm/library/
TV Factory reset codes listing:
http://www.badcaps.net/forum/showthread.php?t=24809Comment
-
Re: Need help identifying replacement part
I use Google's filters:
To reduce the number of hits, I use a search term which usually appears in datasheets but not in other documents:
Edit: The "CS830F A9RD" plastic version (TO-220F) has a power rating of 30W. The "A3RD" version has a higher rating of 75W.
(CS830F A9RD, TO-220F)
(CS830 A8RD, TO-220AB)
(CS830 A4RD, TO-252)
(CS830 A3RD, TO-251)
http://www.crhj.com.cn/cn/product.php?p=8Comment
-
Comment
-
Re: Need help identifying replacement part
Wuxi China Resources Huajing Microelectronics Co., Ltd
http://www.crhj.com.cn/cn/index.php
http://www.crhj.com.cn/cn/images/logo.png
http://www.crmicro.com/Home/Comment
Related Topics
Collapse
-
by the_remHello guys,
I would like a quite old but still good 800 W ATX PSU to be repaired. The problem was an extremely heavy coil whine coming from the small secondary transfomer on the PCB.
I desoldered it hoping the references on the upper side would allow me to find a adequate replacement part. Sadly the written references drove me nowhere but to the manufacturer (I-MAG). I sent them a message like a bottle in the see asking them to send me a datasheet of the transformer. And... They responded ! I received a kind of datasheet (see attachment) but my competencies do not allow... -
by taurtntHi everyone,
I’m trying to identify a step-down regulator marked AMCH073. It’s used on the PEX power rail of a graphics card. I can’t find any datasheet or info online.
Here’s what I’ve observed:
• It has a QFN-16 footprint, similar to NB670.
• Pins 1, 2, 15, 16 are connected together and go to the inductor, so likely SW (switch node).
• Pin 9 is connected to GND, which doesn’t match NB670 (where pin 9 is SW).
• Pin 8 also seems to be tied to the same GND plane.
• The chip only says AMCH073, no manufacturer logo or other markings....1 Photo -
by VoicE2000Hello all, Can anybody help me identifying this part its on the usb c line on a hp elite x2 ,Seem like a filter or cap ,or some sort of short or polarity protection.anyway its blown.
... -
by edugimenoHi There!
I'm trying to help my friend who owns a restaurant be just bought.
He has a very long LED strip running along all the walls and columns. The strip is attached facing down 2in above the floor, using a wall panel that ends in a metal rail that finishes the panel underneath
It's stuck using, I guess, the 2 sided tape that comes with the strip
The issue is that like 1/2 of the full length, including 1/2 one wall, another entire wall, and one column, flickers after 4 or 5 minutes ON. Particularly it flashes staying OFF most of the time and flashing ON for 1 tenth... -
by G-StingSo My iPad was not charging and booting up . i went to a local technician and he checked with thermal and this Part marked in 1st Photo is Short.
So then i went on to boardview and downloaded the schematics and identified this part in 2nd Photo. Now i am confused what exactly is the part called ? where should i get this from ?
i contacted my technician and he sent me his BoardVIew screenshot in 3rd Photo. In his Boardview the part is called X2826.... Something
SO My main concern is what part should i order what should i search the name for ?
on Ipad...4 Photos - Loading...
- No more items.
Comment