I am replacing SCK-20100 NTC Thermistors but can't seem to find em anywhere. I did find a product mfg by Ametherm that might work?
Edit: Or this one?
Thoughts?
Thanks
Edit: Or this one?
Thoughts?
Thanks
-
-
Re: Is this a suitable replacement for a NTC Thermistor?
yes they ARE COMPATIBLE!Things I've fixed: anything from semis to crappy Chinese $2 radios, and now an IoT Dildo....
"Dude, this is Wyoming, i hopped on and sent 'er. No fucking around." -- Me
Excuse me while i do something dangerous
You must have a sad, sad boring life if you hate on people harmlessly enjoying life with an animal costume.
Sometimes you need to break shit to fix it.... Thats why my lawnmower doesn't have a deadman switch or engine brake anymore
Follow the white rabbit. -
Re: Is this a suitable replacement for a NTC Thermistor?
Did you buy them and where? Did they work?Comment
-
Re: Is this a suitable replacement for a NTC Thermistor?
I have seen this in other sets where the relay contacts are bad and all the current continues to flow through the icl causing it to burn up.
SCK 20100 10 ohm 5.5 amp
Digikey has 10 ohm 6 amp rated ones SL12 10006
http://www.digikey.com/product-searc...=0&pageSize=25Comment
-
I have a klipsch kda-500 that would turn on and allow me to get into the web management but it was picking up a lot of noise from audio sources so i decided to replace the smd caps on the power supply along with radial one. Some one was in here before me and they basically burned the bottom side of the traces off for the radial cap but i was able to repair it without any real problem. I thought i did a good job sourcing out replacement caps but apparently not and now i can't get the power supply to turn on it just constantly try's to keep turning on. Attached is a picture of the power supply before... -
Hello,
I am not sure where exactly to put this thread, so hopefully this is the best place.
I have a USB fan that has suddenly been unable to increase its speed. It's just stuck on the first speed. This fan has 3 speed settings. Each time you press the power button, the speed of the fan should increase.
The way the button works with each press is: Speed 1 > Speed 2 > Speed 3 > OFF
Speed 2 and 3 don't currently work any more.
I suspect the issue might be with what looks to be some kind of driver IC. It is a 16-pin... -
Hello. I have Industrial Washing Machine PCB.
Customer Requested Relays Replacement.
I can't find WJ115F1 relays to buy. Looking for some help to identify possible alternative solutions.
Or any tips, on how to approach this situation.... -
My 7 channel NAD receiver has audio quality and volume issues on 2 of the channels. Sometimes they work and sometimes they don't. Sometimes they're at about half the dB level of the left channels, and then they cut out entirely. Powering off and on the receiver fixes it for a bit.
Without much experience to really know for certain, they only apparent issue I can see is with these electrolytic capacitors on the power supply. Bulging = bad, correct? I'm looking for replacements but I'm unsure what leeway I have with the temp ratings. Are there any other specifications I need to worry... -
Hello guys,
I would like a quite old but still good 800 W ATX PSU to be repaired. The problem was an extremely heavy coil whine coming from the small secondary transfomer on the PCB.
I desoldered it hoping the references on the upper side would allow me to find a adequate replacement part. Sadly the written references drove me nowhere but to the manufacturer (I-MAG). I sent them a message like a bottle in the see asking them to send me a datasheet of the transformer. And... They responded ! I received a kind of datasheet (see attachment) but my competencies do not allow...
Comment