I think this was easier to implement using a digital controller on the lamp.
My first choice in quality Japanese electrolytics is Nippon Chemi-Con, which has been in business since 1931... the quality of electronics is dependent on the quality of the electrolytics.
Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
we're getting quite a lot wiped A1932 & A2337 from scrap with MDM (Remote management), we'd like to find permanent solution to remove it without CPU swap as it gets not economical, I found iremove.tools website which offer permanent solution, however if they got shut-down i believe laptops would also get locked? Does anyone have any knowledge about this service & about any other possible method?
I want to find a solution, perhaps an ultimate, solution to this dilemma with your expertise. As it stands, the diffuser is too close, if not directly on the joint, there must be a way to separate without affecting image quality, I'm thinking with small glass strips or maybe pieces that make it a little distance, melan, them, or what do you suggest?
In my workshop I have 12 LED lighting battens and the some of the drivers have failed.
In side there is 2 aluminium PCB with a 72 LED on each PCB as โcurrent' Schematic.
I am looking the get some constant current led driver to replace them. is it there any problem wiring as โoption 1' Schematic or is it best as โoption 2' Schematic.
With option 2 I would have to modify the all PCBs, so a lot more work.
Comment