Characteristic Impedance of LC Filter
What is exactly the meaning of the Characteristic Impedance of the LC filter? I know the formula that is SQRT(L/C), but please tell me what does it mean?
Thanks.
Thanks.
-
-
Re: Characteristic Impedance of LC Filter
Characteristic impedance is a term most often used to refer to a transmission line with distributed constants. Shape factor is a better term to describe the characteristics of a particular filter. An LC filter is made up of lumped constants. The resonant frequency in Hz of an LC filter is one on 2pi root LC.
As usual, nothing exists in space, so you often must define what your source and load impedances should be in order for your filter to work properly. Ideally the source and load would be resistive, so they don't interfere with the resonant frequency or the shape of the filter. Ideally, the source and load impedance would be infinite, in order to maximize the Q of the LC circuit.Is it plugged in?
-
Hi, this is more of a project help request than a troubleshooting question. I hope I can post it here.
I have a W-King D8 Bluetooth boom box which I'd like to modify with some external speaker output jacks and some buttons to switch the internal speakers on and off.
From factory the specs of the boom box are:
-Power Input: DC 5V
-Speaker Output Power: 2 x 25W ( confirmed by Youtube channel Hartdegen review as 12.5W RMS per channel)
-Drivers:
-2 x Woofer, 70mm, 10Ω, 70mm,15W
-2 X Tweeter, 8Ω, 30mm,10W x 2
-Frequency... -
Recently acquired one of those silly Logisys acrylic power supplies and lucked into getting one of the "better" ones (most of an input filter, bridge rectifier instead of 4 diode treatment, OK-sized heatsinks, etc.) and wanted to fill out what I can on the board + get some decent caps on there (especially the primary side since I highly doubt the ones in there are actually 1000uf). My questions are:
1. How do I know what components to install re: the input filter? It seem to be missing an X cap, a resistor, and a Y cap.
2. Where can I find a good heatsink for the bridge... -
I know I've been a little scarce lately (like the last 2-3 years), but I'm still here and still doing my thing with fixing PSUs.
For today's considerations, I have a Seasonic B12 BC-550 [A551bcafh] 550 Watt ATX power supply for you (click on links for full size images).
https://www.badcaps.net/filedata/fetch?id=3591771
https://www.badcaps.net/filedata/fetch?id=3591772
It's a modern ATX unit with fixed (non-modular) cables and an 80-plus bronze certificate. Here's the label:
https://www.badcaps.net/filedata/fetch?id=359177... -
Hi
I'm trying to locate what i believe to be Radial Electrolytic Capacitors 100v 82uf Non-polar for a Skytec Crossover filter.
Thanks -
I have a question - I have replaced the PSU on my own iMac Pro. However, when removing the motherboard I knocked of a 120 OHM 30% 0.3A small surface mount common mode inductor/filter (~0602 size) in the ethernet circuit near the female RJ45 port.
The closest match I can find on Mouser is 120 OHM common mode inductor at 100MHz - my question is this frequency correct for a motherboard? The schematic for the motherboard only provides '120 OHM 30% 0.3A' and the TDK part number does not return anything in google.
Sorry, I am not experienced hence a basic question.
...
Comment