I used skypro programmer for years (on win7) and didnt have any problems...but years pass and have cleaned it couple of times so i decided its time for new skypro (same version).
In that time i had also build a new computer and install win 10.
The programmer arrived from China from the seller that old buyers commented that it is legit seller of that programmer.
it looks like this:
The problem is that it is not detecting chips with statement "chip not recognised".
I tried to install different version of software (from CORIGHT page)...different usb cables...different ports...tried on different computer (also win 10) but its allways the same. It is recognising programmer with statement "device is connected" but when i press detect chip...its allways "chip not recognised"
I am out of ideas...any help?
In that time i had also build a new computer and install win 10.
The programmer arrived from China from the seller that old buyers commented that it is legit seller of that programmer.
it looks like this:
The problem is that it is not detecting chips with statement "chip not recognised".
I tried to install different version of software (from CORIGHT page)...different usb cables...different ports...tried on different computer (also win 10) but its allways the same. It is recognising programmer with statement "device is connected" but when i press detect chip...its allways "chip not recognised"
I am out of ideas...any help?
In the end the programmer started to work after maybe 50 firmware installation...I am not sure what cause or fixed the problem...maybe it was bad usb cable that caused bad firmware installation... 
but that doesnt make much sense...anyway suddenly after one firmware installation eveeything was fine. I even reinstall it couple of times to see if problem will start again...but no...everything is perfect
Comment