From facebook group. It's 8p8c but just a bit narrower
Attached Files
-
Cap Datasheet Depot: http://www.paullinebarger.net/DS/
^If you have datasheets not listed PM me -
Re: What connector is this?
is it ethernet ? -
Re: What connector is this?
no, it's a variant of a u.s. phone plugComment
-
Re: What connector is this?
It's starting to lead me into AT&T Merlin, but I can't tell the widthCap Datasheet Depot: http://www.paullinebarger.net/DS/
^If you have datasheets not listed PM meComment
-
Re: What connector is this?
why do you have a small telephone switchboard??
not seen one of those for decades!!Comment
-
Re: What connector is this?
Someone on a telephony forum figured it out pretty quickly, RJ31XCap Datasheet Depot: http://www.paullinebarger.net/DS/
^If you have datasheets not listed PM meComment
-
Re: What connector is this?
Actually he now takes it back lolCap Datasheet Depot: http://www.paullinebarger.net/DS/
^If you have datasheets not listed PM meComment
-
Re: What connector is this?
they can't really figure it out either
https://sundance-communications.com/...598#Post643598Cap Datasheet Depot: http://www.paullinebarger.net/DS/
^If you have datasheets not listed PM meComment
-
Re: What connector is this?
ethernet?Comment
-
Cap Datasheet Depot: http://www.paullinebarger.net/DS/
^If you have datasheets not listed PM meComment
-
Hi All -
I had replaced my ASUS 4090 Strix cooler with a waterblock and put the stock cooler on the shelf. Was moving it and snagged my sweater on the connector and pulled the wires out of the pins on the RGB connector. I tried to get them back on but its too small so I opened the stamped pins and tried to solder but its not a good repair and the wire broke on reinstallation.
Looking to replace the connector on the cable side and get pins to crimp onto a new cable. Bought random JST and such but nothing is correct. Can anyone help identify the connector and possibly matching... -
Hello All,
tl;dr: minimal electronics experience and my first repair, lifted 8 pads off the laptop display LED controller board when attempting a connector replacement, options are attempting pad repair or jump wiring.
Laptop Model: MacBook Pro 15 Mid-2014 Retina, A1398 MGXA2LL/A
eDP Display: Samsung LSN154YL01-A02, assembly sold as Apple part 661-8310
Soldering Equipment: Hakko FX-888D w/ T-18 tips (Chisel, Conical, Bevel types)
I needed to replace the 30-pin I-PEX Cabline connector (labeled J8300 in the Apple 820-3662 mainboard schematics),... -
Hi guys,
i have a damaged keyboard connector on my older Toshiba Satellite M50-A laptop. I know there is LA-A481P motherboard. In attachment pictures there is a real looking connector and i also found a schematic to the connector. But i need help with finding a real electronic part to replace the damaged connector. e.g. on aliexpress (or different page).
It is 34pin connector and the length from pin n.1 to pin n.34 is 26mm. So it means a pitch length is 0.764 mm. I have seen connectors with 0.5mm , 0.7mm , 0.8mm and 1mm pitch length. But not with 0.75. Is it some special custom connector... -
Hi everyone
I have a 70mai Dash Cam A510 which failed after about 3 months of being installed in my car, likely due to heat, i got it from aliexpress so no point in trying to return it for warranty (and shipping it back would cost me almost the same as a new one from ali)
The camera would boot loop showing 70mai logo on the screen, sometimes it would boot fine then the live view would freeze or display purple lines
I already took it apart, and found out that the camera boots fine if i unplug the camera module from the main PCB, sometimes "playing" with the connector... -
Trying to identify where to source the LCD connectors on the motherboard side for a HP 14-cf2051la. This one came in with liquid damage to the connector and the flex cable. It appeared to clean up ok, however customer says that display blanks out intermittently. It's a 30 pin EDP flat ribbon cable on motherboard side. Believe it to be a HEDWIG-6050A3155301-MB-A01 motherboard.
I've stolen the connector from another HP motherboard which matches up but it's not the best since it's been kicking around my donor pile for a while. This connector is different to most flip type ones I have...
Comment