If the capacitor rating is identical but if the replacement capacitor is smaller in size, does it matter?
Question about capacitor size with same rating
Collapse
X
-
Re: Question about capacitor size with same rating
If by "rating" you mean capacitance and voltage, it often does matter, because the temperature, impedance, and ripple current rating often matter a lot.
On the other hand, if you are comparing a 30 year old capacitor and a 2021 manufactured capacitor of the same capacitance, voltage, temperature, impedance, and ripple current ratings, the newer part might be smaller, due to technology progress.PeteS in CA
Power Supplies should be boring: No loud noises, no bright flashes, and no bad smells.
****************************
To kill personal responsibility, initiative or success, punish it by taxing it. To encourage irresponsibility, improvidence, dependence and failure, reward it by subsidizing it.
**************************** -
Re: Question about capacitor size with same rating
If by "rating" you mean capacitance and voltage, it often does matter, because the temperature, impedance, and ripple current rating often matter a lot.
On the other hand, if you are comparing a 30 year old capacitor and a 2021 manufactured capacitor of the same capacitance, voltage, temperature, impedance, and ripple current ratings, the newer part might be smaller, due to technology progress.Comment
-
Re: Question about capacitor size with same rating
just some information here
https://www.badcaps.net/forum/showthread.php?t=26134
https://www.badcaps.net/forum/showthread.php?t=18911
https://www.badcaps.net/forum/showthread.php?t=53198Last edited by AleXis6; 10-20-2021, 12:05 AM.Comment
Related Topics
Collapse
-
by chth96When I tried to repair LG 29 inch CRT TV, I found that the ESR value of samyoung SMS capacitor(160v 2.2uf), which is very close to D1879 transistor, is 6 ohm.
Judging from above ESR Meter Table,I think It is necessary to replace this sms capacitor.So I visited local electronics shop,and I purchased 160v 2.2uf rubycon YK capacitor.
But when I browse through rubycon YK datasheet,I found that there is no ripple current rating for 160v 2.2uf specification. But On the contrary, I found 39 mA ripple current rating for 160v 2.2uf SMS capacitor.
Rubycon YK DataSheet (b...-
Channel: General Capacitor Questions & Issues
-
-
by Per Hansson(TL;DR skip the first paragraph)
I encountered my first dead motor run capacitor at a customer this week.
For some fields I guess it is a very common occurrence but the usual way for industrial machines here is to use 3-phase motors.
(Unless a servo motor makes more sense that is).
But for some reason this 3-phase machine uses a 1-phase motor for its liquid coolant pump.
The pump would run but sometimes trip the 10A breaker.
I monitored it starting and stopping for over an hour until it finally stopped in a specific spot between its windings:
Then it could... -
by howardc64Problem
This is an LG edge LED lit LCD Display. The LEDs are on the bottom edge of the display. There are 2 bars (left and right) Each bar has many LEDs and a 6 pin connector. Each pin drive several LEDs thus is the highest current flow / heat junction. The weak lead free solder gradually fails with thermal expansion/contraction cycling and increases resistance. PSU will compensate up to a point, then when the current is too high, PSU just shut down the backlight causing a dark display. I have even seen one which the connector just fell off as solder points became completely detached....-
Channel: Troubleshooting Computer Displays
-
-
by PrologHi people, I hope this is the correct spot to post this, I'm new to the forum.
I have an RTX 3080 Founders Edition which has a burnt up capacitor (it was in parallel with another capacitor which appears damaged too), so I am hoping to be able to identify the capacitor values and order replacements.
I hope these photos make it clear which component I am referring to:
(yes, the soldering is a bit botched from removing the blown one, I know)
I have found the board schematic (attached), but there does not seem to be a boardview available. I have never... -
by AdenitzHello,
I'm reading an article about the "capacitor plaque" in early 2000s and I have found one sentence I cannot understand.
The normal lifespan of a non-solid electrolytic capacitor of consumer quality, typically rated at 2000 h/85 °C and operating at 40 °C, is roughly 6 years. It can be more than 10 years for a 1000 h/105 °C capacitor operating at 40 °C.
What this 2000h or 1000h means? Why 1000h capacitors have longer life span?-
Channel: General Capacitor Questions & Issues
-
- Loading...
- No more items.
Comment