Just had these capacitors blow. Can anyone send a link to where i can buy these specifically? I just want to be positive i get the right ones. Thanks in advance!
Attached Files
-
-
Re: Need help finding specific capacitor
Looks to me that these are 25 uF / 25 Volts - they are smd capacitors
There are many good brands : like Panasonic , Nichicon , Elna ,
You can find them on Mouser , Digikey , and other places -
Re: Need help finding specific capacitor
More like 100uf 25V .Looks like a laptop motherboard,the schematic,if available would tell you for certain what they are.Comment
-
Re: Need help finding specific capacitor
Yea I determined that they’re 100uf 25v. There are no schematics available, unfortunately. However i just bought some that are 100uf, 25v, and are a similar size on mouser. Hopefully they’re close enough to workComment
-
Re: Need help finding specific capacitor
so was it you that baked them? i see all that flux!!
Comment
-
Re: Need help finding specific capacitor
Yep :p i was attempting to remove the MOSFET you see next to it, but my hot air station couldn’t do it fast enough. I even had some kapton tape on the caps. End result: blown cap and still bad mosfet on the boardComment
-
Re: Need help finding specific capacitor
Ok so 100 uF - -
I thought that the last number in the 100 - so the last zero (0) was the multiplier.
So for a 100 uF cap it would be printed on the cap 101 - or is this wrong ??
That would be a 10 + 1 extra zero - (or is this only for non electrolytic small caps ?)Comment
-
Hi people, I hope this is the correct spot to post this, I'm new to the forum.
I have an RTX 3080 Founders Edition which has a burnt up capacitor (it was in parallel with another capacitor which appears damaged too), so I am hoping to be able to identify the capacitor values and order replacements.
I hope these photos make it clear which component I am referring to:
(yes, the soldering is a bit botched from removing the blown one, I know)
I have found the board schematic (attached), but there does not seem to be a boardview available. I have never... -
I replaced some capacitor which is located on optical pickup pcb which is shown in the table below(PCB #2).Because it have been out of order.
Now,It works very well,But I just have found that all caps (6svpc100my and other part number as well) ,which is shown in the table below, has ultra-high ripple current spec.
It is not able to obtain any capacitor which can be a substitute for this ultra-high ripple current nichicon capacitor.
So I replaced it with samxon and rubycon's general capacitor(GP,YXA series).
I know that these capacitor will not last as long as nichicon capacitor... -
I desoldered samwha NF capacitor(50v 5.6uf) from PCB circuit of 29inch CRT TV which have symptoms of no display after I heard sound of inrush of current to TV whenever I switch on this television.
I measured ESR value of this non-polarized capacitor(samwha NF capacitor 50v 5.6uf) by means of MESR-100 ESR meter and It displayed 0.3 ohm
And When I measured its capacitance with digital multimeter and LCR-T4 Mega328 meter, It displayed 10uf from DMM and 8uf from LCR-T4 meter.
I found catalogue of samwha capacitor(samwha-catalogue_3.pdf file), which is attached to this thread,... -
When I tried to repair LG 29 inch CRT TV, I found that the ESR value of samyoung SMS capacitor(160v 2.2uf), which is very close to D1879 transistor, is 6 ohm.
Judging from above ESR Meter Table,I think It is necessary to replace this sms capacitor.So I visited local electronics shop,and I purchased 160v 2.2uf rubycon YK capacitor.
But when I browse through rubycon YK datasheet,I found that there is no ripple current rating for 160v 2.2uf specification. But On the contrary, I found 39 mA ripple current rating for 160v 2.2uf SMS capacitor.
Rubycon YK DataSheet (b... -
a few days ago I finally purchased mser-100 v2 and I tested its abillity of measuring ESR value.
I found that It shows pretty accurate ESR value for electrolytic capacitor,But When I measure polymer capacitor of dreamcast game console,I found that one third of polymer capacitor's ESR value is more than twice the value of ESR meter table.(for example, I measured one polymer capacitor of 6.3v 100uf, It showed ESR value of 7.68)
Although my dreamcast now turns 20 years old but it still works. I occasionally have played game with it.
Is this ESR value of polymer capacitor correct?...
Comment