Hello, nice to meet you all
New Members - please post your introductions here
Collapse
This is a sticky topic.
X
X
-
-
Comment
-
Hey! I am a hobbyist repairer, looking forward probably getting a side gig in a local repair center!
I spent about three years working on different computers, laptops, tablets, phones, and game consoles, but due to me being still in high school, I don't have as much time as I would like.
Looking forward to hanging out here!
Comment
-
Hi my dear,
I am Ailontania, and I come from Tokyo.
I have been playing computers since I was 7 years old.
I hope to make friends here and contribute my knowledge.
Comment
-
Hello everyone! My name is Ruslan. I am from Russia. I repair various electronics. My hobby has grown into a job. I like your community and sharing experiences with you. Greetings from *******Comment
-
-
Related Topics
Collapse
-
by fredyjbiplease help friends thinkpad T470 board CT470 series NM-A931 error post "bottom cover tamper detection error"
I've already
flashed the bios clean me and updated from the Lenovo site, then removed the switch and immediately jumped the S3 from pins 1 to 4, 2 to 3 but the problem remained the same, thank you1 Photo -
by fredyjbiplease help friends, I have 3 T490 units with the same case, the USB type C is completely dead, showing 20v 0 amp, loss of voltage VINT20_IN resistance to ground is fine, thank you
I think the problem is that I lost the voltage at PQ0008 pon 1 -PWRSHUTDOWN which should have been high which was picked up by R9512 VCC3SW, thank you very much for your help
PF0002 20v
PQ0005
pin 5 20v
pin 1.2.3 19.8v
pin 4 19.8
resistance
source & drain 2,4 m
source & gate 100k
PQ0006
pin 1.2.3 19.8v
pin 4 19.8v... -
by fredyjbiplease help friends x1 yoga 7th no display beep melody thank you...
-
Channel: BIOS Requests ONLY!
-
-
by fredyjbiplease help friends clean me bios x1 yoga 7th no display melody beep, thank you
-
Channel: BIOS Requests ONLY!
-
-
by fredyjbiPlease help friends, thinkpad t480 nm-b501 is dead, help me fix it, thank you
usb meter 20v 0.00 amp, after I took the VSYS measurement the drop was only `9.2v which should have been 10.2v I measured from a normal matherboard machine, the VSYS path resistance to ground diode mode is 1900 thank you
LINK to Schematic -> https://www.badcaps.net/forum/troubl...b501-schematic - Loading...
- No more items.
Comment