Hello!
I was replacing a lot of swollen electrolytes inside the powersupply board of a Swedx LCD TV. After this the set starts up fine, but the screen will not show any picture (just a very very dark faint blue) even if there are video signal applied to the scart. Also, it's not possible to get to the menu or anything, absolutely no life on the screen. UNTIL you pull the scart and put it back.
Then the picture displays and everything works as normal.
I don't have the model number right in front of me, but will have it later.
Just wanted to pre-post this.
I was replacing a lot of swollen electrolytes inside the powersupply board of a Swedx LCD TV. After this the set starts up fine, but the screen will not show any picture (just a very very dark faint blue) even if there are video signal applied to the scart. Also, it's not possible to get to the menu or anything, absolutely no life on the screen. UNTIL you pull the scart and put it back.
Then the picture displays and everything works as normal.
I don't have the model number right in front of me, but will have it later.
Just wanted to pre-post this.