JVC TV Model LT-65N675- No picture

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Electronic Centre
    Member
    • Mar 2017
    • 11
    • BOTSWANA

    #21
    Re: JVC TV Model LT-65N675- No picture

    Hi Angelos. Did u come right with LT-65N675 after ordering the T-con board?. I just met the same problem as yours. Backlight comes on but no data. DC-DC voltages missing without any short circuits.

    Comment

    Related Topics

    Collapse

    • rimwall
      Sony KD-65x7500D - double image - Tcon or Panel?
      by rimwall
      This TV was showing a fine image and pulsing with a partial double image (offset vertically) every few seconds. I taped 8 clock pins on one ribbon cable from the Tcon to the panel. It stopped the double image, but some pulsing in intensity was still visible. I then taped another 8 clock pins on the same ribbon cable and the image is now ‘fixed’. Although I understand this results in some loss of resolution, presumably because the clock signal degrades as it passes horizontally across the screen.

      I am wondering - do these symptoms and ‘fix’ mean that it’s a Tcon fault or...
      11-18-2025, 02:09 AM
    • TR103
      Samsung TV model UE50TU: rebooting, backlight, sound, but no picture
      by TR103
      Hi, I have a Samsung UE50TU with:
      - sound and backlight, but no picture
      - when it arrived, it had a picture for a few seconds
      - it keeps rebooting
      - without ribbon cable between the two panel boards, it does not reboot but I have no picture
      - without cable between mainboard and lcd panel, it does not reboot (but obviously i have no picture)
      - when i try a tape fix, its keeps rebooting, unless I tape off pin 1 (the innermost pin). In that case it does not reboot but I have no picture.

      - without cable between mainboard and lcd panel and with a jumpered...
      01-22-2025, 04:12 PM
    • kca
      LG 82UN8570AUD ~ TCON or PANEL?
      by kca
      Hello all ~

      Hope this finds you well. This LG 82UN8570AUD (April 2021 model) 4K UHD television has full audio capabilities but video is compromised / problematic.

      When I picked up this large LG tv it had a full black screen upon startup. Previous owner said it just went black one day. No popping sound or anything else of note.

      I got the display to work by taping off several traces of the right-hand side ribbon cable on the TCON that leads from TCON to PANEL. However, despite dozens and dozens of attempts to find the right combination / range of traces taped...
      08-31-2025, 06:38 AM
    • netgearnetgear
      TCL 43S423 TCON OR PANEL FAULTY???
      by netgearnetgear
      Good day, I have a TCL TV: Model 43s423. After turning ON the TV, the ROKU TV logo appears with fine lines over the whole screen, then after a while there are vertical bands in the middle of the screen top to bottom and the TV tries to update its firmware but I do not have the remote to connect it to my new network connection. Also the Power ON light blinks 2 times in quick succession. When I remove the ribbon on the right of the tcon board the left side of the screen shows but with fine lines. If I remove the left side ribbon and connect the right side ribbon the whole screen is blank with...
      08-20-2025, 06:04 PM
    • iglitare
      Sony KD-75XF9005 grey Picture but Sound. TCON or panel?
      by iglitare
      Hi,

      i want to repair a Sony KD-75XF9005 TV that initially only showed a grey picture.
      Backlight seems to work, Sound (Setup menu after reset) works.
      If i dissconnect the left FFC cable from TCON to panel i have half a screen on the right. If left cable is connected always only the grey screen.
      Interchanged the cables, its always only the right side that is working. Always grey if left side is connected.
      With my small knowledge i would think at least the cables are good.

      Can this happen because of a bad tcon board?
      Or is it always a bad/shorted...
      09-04-2025, 07:13 AM
    • Loading...
    • No more items.
    Working...