tx-l42wt50b Panasonic wont turn on

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • adamp91gvm
    Badcaps Veteran
    • Jan 2014
    • 699
    • uk

    #1

    tx-l42wt50b Panasonic wont turn on

    I have a Panasonic wont turn on just flashed red lights any ideas thank you
  • adamp91gvm
    Badcaps Veteran
    • Jan 2014
    • 699
    • uk

    #2
    Re: tx-l42wt50b Panasonic wont turn on

    Does nothing at all red light just flashes

    Comment

    • neilc6
      Badcaps Legend
      • Nov 2015
      • 1550
      • Canada

      #3
      Re: tx-l42wt50b Panasonic wont turn on

      Service manual here https://www.electronica-pt.com/esque...a34-lcd-29737/

      Blink codes on page 16. One blink is Backlight SOS - bad backlights.

      Comment

      • adamp91gvm
        Badcaps Veteran
        • Jan 2014
        • 699
        • uk

        #4
        Re: tx-l42wt50b Panasonic wont turn on

        Tried it the power going to the av is up and down from 15.6v to 5v the screen flashes on for a second and goes off

        Comment

        • neilc6
          Badcaps Legend
          • Nov 2015
          • 1550
          • Canada

          #5
          Re: tx-l42wt50b Panasonic wont turn on

          The backlights flashing on power up is a symptom of bad backlights causing an under or overvaltage situation which is detected and triggering a shutdown. A LED tester can help you confirm.

          Comment

          • adamp91gvm
            Badcaps Veteran
            • Jan 2014
            • 699
            • uk

            #6
            Re: tx-l42wt50b Panasonic wont turn on

            Fixed bit of heat to the av board boom

            Comment

            Related Topics

            Collapse

            • cloo
              Panasonic ZT60 plasma tv with strange behavior and 8 blink code
              by cloo
              I recently got my hands on a 60" Panasonic P60ZT60 plasma tv (european model) that has some strange issues along with an 8 blink code.
              It know this tv is getting old but it was once considered one of the best plasmas ever made, and i think it is still holds on to that even by todays standards.


              So, long story short. When i first got the tv it had a very bright washed out picture with very raised blacks in all picture modes and i couldn't find the cause in the picture setting menus.
              After doing a factory reset this problem was gone and the picture was back to...
              01-06-2025, 06:02 AM
            • gabrielA7
              IMAC A1418 / MB: 820-00430-a / does not turn on, Lights 3 of the 4 LEDs and turns off.
              by gabrielA7
              Does not turn on, lights 3 of the 4 LEDs and turns off and stays like this, presses the power and repeats.
              I saw that the room LED lights up only when the screen is connected, so quiet.

              We have all the power supplies, even processor, 1.8V
              One thing I found strange, it has a very low resistance in the Vcore is giving 1 Ohm , work with notes and such, I know that this is normal in some processors but with this resistance only take video card so found it strange.

              I suspect that there may be some leak in the processor.
              Anyway, when I press the power, it...
              10-29-2024, 06:48 AM
            • madsox
              Harman Kardon AVR 171S - standby led lights up, does not turn on
              by madsox
              Greetings!

              Thank you in advance for your understanding, I am writing to you through a translator.

              A Harman Kardon AVR171S amplifier was given.

              The history of the machine is as follows:
              It was faulty when I bought it, I want to fix it.
              I replaced the HDMI switch and one of the DAC ICs in it.
              After that it worked without a problem.

              I watched a movie using the amplifier, and at the end the amplifier got really hot.
              The cooling was faulty, I will fix this later.
              I switched it to standby mode, waited for...
              09-24-2022, 10:46 AM
            • pajdek
              Lenovo Y700-17ISK turn on and off
              by pajdek
              Hello, i have some issues with my laptop Lenovo Y700-17ISK (motherboard BY511 NM-A541), it started when i turn on the laptop, but the lcd wont turn on, i then connected it via hdmi to tv and screen was ok. So i thought maybe lcd stripe is faulty, i removed the bottom cover, disconnected main battery, reset the cmos by disconnecting battery for 1 min, then slighty move the lcd stripe. Conncted power supply and tuned on my laptop, the lcd turn on, it started to load os, then it turn off, after a second it turn on, then after like 3 seconds turn off again, and so on. Removed power supply, waited...
              09-20-2023, 02:49 AM
            • letsfixthis
              Acer VN7-791 - Flashed cleaned BIOS - Laptop wont turn off
              by letsfixthis
              Hey,

              I have been trying since 2 days to get this working.

              The Acer VN7-791 had the 30 Minutes shutdown issue.
              Therefore I desoldered the BIOS, cleaned the ME Region (with the Win-Raid guide) and Flashed the Version again.

              It seems to have solved the reboot issues.

              But unfortunately now I cannot turn off the computer anymore. It just reboots when I do it via Windows 10 or the Power Button. Only thing working is hard Reset via long press of the Power Button.

              I tried to install an older Version of Mangement Engine...
              10-13-2023, 04:29 AM
            • Loading...
            • No more items.
            Working...