LG 28MN30D - PZ channel scan problem

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • RoLOMiX
    Member
    • Apr 2012
    • 10
    • Portugal

    #1

    LG 28MN30D - PZ channel scan problem

    Hello, i have this LG 28MN30D - PZ and when i try to scan for channels the tv reboots, i think the problem is on the firmware, can sonmeone share the dump? Please Help
    LC31A/26LN4500/EAX65359602 (1.2)
    Thanks
  • RoLOMiX
    Member
    • Apr 2012
    • 10
    • Portugal

    #2
    Re: LG 28MN30D - PZ channel scan problem

    Anyone? Please? Thanks in advanced

    Comment

    Related Topics

    Collapse

    • eccerr0r
      old X58 triple channel board... memtest86 memory speed?
      by eccerr0r
      Anyone run memory speed tests with an old X58-based triple channel 1st gen or any other >2 channel board? The one I have is a Gigabyte I think.

      Anyway I had four 4GB DDR3-1333 modules in the 6 memory slots and got around 11GB/sec memory speeds assuming that it went dual channel since it didn't have enough modules for triple channel. Now I stuck in two more 4GB modules, but they are DDR3-1600. I'm still getting 11GB/sec speeds according to memtest86...

      Just wondering, anyone do memory speed analysis on these triple (and higher) channel memory boards? Are there any...
      06-28-2025, 09:06 AM
    • spleenharvester
      Reverse engineering of 18650 4-channel tester
      by spleenharvester
      Hi friends

      I have reverse engineered this tester, schematic is attached and is complete except for capacitor values. These testers annoyingly have no model number but they are the ones you find on the first page of just about any website if you type in "18650 4-channel tester". There is also a 2-channel variant and a newer 8-channel variant. They are very cheap (about £15) and can measure voltage, current, internal resistance and capacity. They have a multicolour display for all these statistics. They also have terminal blocks so that if you want to use a breakout board...
      05-04-2025, 02:43 AM
    • theone111
      Problem with LG Plasma 60PM6700 - Random power downs
      by theone111
      I have an LG Plasma TV 60PM6700 for the past ~12 years.

      In the last ~3-4 months I have been having some issues.
      1. Problem: It started with random picture disappearing (sound still worked).
        Frequency: Happened about once a week.
        Solution: Had to turn off TV wait a few seconds before turning it on again.
      2. Problem: Then it got worse and the TV started to shut down and when turning on the no picture just sound.
        Frequency: Happened about once a week.
        Solution: Had to turn off TV wait about 10-20 seconds and turn it on again to solve.
      3. Problem: TV shuts down
      ...
      07-22-2024, 10:36 AM
    • dicky96
      Hitachi V19B01922 Channel Tune problem
      by dicky96
      Hi Guys
      I have a customer who has two Hitachi TVs in his bar, one is the model in the thread title and the other is a larger screen but has the same setup menu

      He also has an LG TV, so three screens in the bar

      I installed three Satlink ST-6503 DVB-T Modulators
      This model https://www.aliexpress.com/item/32916553905.html

      These connect to three satellite receivers via HDMI cables and then connect to a 4 way RF Amp that connects to the TVs on aerial cable. There is no incoming terrestrial antenna. I set the channel ID on the modulators to...
      02-09-2023, 09:20 AM
    • Zeonalbasta
      Thinkpad X1 Carbon "LMQ-1MB 12298-2 48.4LY26.021" VCC3M problem
      by Zeonalbasta
      i have a problem with thinkpad X1 carbon gen 2 "LMQ-1MB 12298-2 48.4LY26.021"
      The laptop was turned off because the MOSFET was not transmitting voltage. After checking it turned out that the gate pin on the MOSFET was the problem, because it was producing an inappropriate voltage. and it was discovered that the problem was with the Think engine, so I decided to reprint each pin, and finally the mosfet could work properly. However, there is another problem, even though the voltage has been supplied to the laptop, it still won't turn on, there isn't even an LED indicator. After double...
      09-13-2024, 01:17 PM
    • Loading...
    • No more items.
    Working...